Advertisement
ROBOT05
Robot car kit for Raspberry Pi & Arduino
1. INTRODUCTION & OVERVIEW
Dear customer,
thank you for choosing our product. In the following, we will show what
you should note at the commissioning and during the usage.
Should you encounter any unexpected problems during use, please do not
hesitate to contact us.
The Robot Car Kit 05 is a construction set which can function as the basic
structure for a car / robot. You must add yourself further components like an
energy source (batteries) and a control like for example an Arduino with a
motor controller. We recommend using Joy-IT appurtenances.
motor voltage
current (idle)
4.5 - 9V DC
190 - 200mA
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Joy-it ROBOT05
Summary of Contents for Joy-it ROBOT05
- Page 1 / robot. You must add yourself further components like an energy source (batteries) and a control like for example an Arduino with a motor controller. We recommend using Joy-IT appurtenances. motor voltage 4.5 - 9V DC...
- Page 2 Included materials: 1x base plate 1x mounting plate 1x mounting plate kit 4x screws (M3x30) 4x nuts (M3) 2x screws (M3x10) 1x front axle 2x motors 2x wheels 2x perforated discs...
- Page 3 4x motor brackets 4x spacers 1x battery compartment 1x switch 2. SAFETY INSTRUCTIONS The device must not be unsupervised. Separate the power supply or rather the voltage source (e.g. batteries) if you are not using the device. This device is not a toy. It contains swallowable small parts and it is not appropriate for children.
- Page 4 3. ASSEMBLY Attention! We recommend installing supply lines for the motors before the assembly of the vehicle. First, apply the motor brackets and the switch onto the base plate. But befo- rehand, remove the yellow protective film. The axle hole of the perforated discs have a broad and a slim side. The broad side should point to the motor.
- Page 5 Now screw the motor tight. Mount the battery compartment.
- Page 6 Put in the spacers and mount the front axle. Now mount the mounting plate with the help of the enclosed mounting pla- te kit. The according mounting holes for Robot05 are marked on the moun- ting plate as R1. The assembly is now finished. You can mount a microcontroller of your...
- Page 7 We send you a parcel stamp with which you can send us your old appliance free of charge. For this possibility, you must contact us via e-mail at service@joy-it.net or via telephone. information about packaging: Please package your old appliance safe during transport. Should you not have a suitable packaging material or you do not want to use your own material, you can contact us and we will send you an appropriate package.
- Page 8 If any questions remain open or problems arise after your purchase, we are available by e-mail, telephone and with a ticket support system to answer these. E-Mail: service@joy-it.net Ticket-System: http://support.joy-it.net Telephone: +49 (0)2845 98469 – 66 (10 - 17 o‘clock) For further information visit our website: www.joy-it.net...
Need help?
Do you have a question about the ROBOT05 and is the answer not in the manual?
Questions and answers