Advertisement
Advertisement
Table of Contents
Summary of Contents for Handlink Technologies HL-11N
- Page 1 HL-11N 802.11n WLAN Mini-PCI Module User’s Manual...
- Page 2 FCC Statement Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired...
- Page 3 "Contains TX FCC ID: TWS-HL-11N". RF Exposure Manual Information That Must be Included The users manual for end users must include the following information in a prominent location "IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna...
- Page 4 802.11g/n technology and compatible for interoperability with existing 802.11b devices. This device provides 300Mbps transfer rate in wireless network. HL-11N is designed for Printer Server series, IP Camera series and Internet Video Server gives you wireless access the web and network resource without the wire.
- Page 5 2. Hardware Installation The following sections in this chapter describe how to install HL-11N Module 2.1. Installation Overview HL-11N wireless module is design for Wireless Gateway only. 2.2. Safety Recommendations The safety guidelines are as follows: λ Keep the board area clear and dust-free before, during, and after installation.
- Page 6 Remove the HL-11N module from its protective packaging. λ Avoiding Electrostatic Discharge Before you install the HL-11N module, ground yourself by touching a piece of metal to avoid electrostatic discharge (ESD). You should also take the following precautions to prevent damage to the HL-11N module: λ...
Need help?
Do you have a question about the HL-11N and is the answer not in the manual?
Questions and answers