Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for GIGA-TMS UHF880
- Page 1 UHF880 Hardware User Guide...
- Page 2 Any part of the contents of this document, without the express written GIGA-TMS permission, shall not in any documents, electronic, mechanical form of remakes or spread. File contents are subject to change without notice. Revisions Revision Date Description Sep 30,2020...
- Page 3 Has been tested in accordance to essential protection requirements of the RED – DIRECTIVE 2014/53/EU, EU-LOW VOLTAGE DIRECTIVE 2014/35/EU on the approximation of the laws of the Member States relating to Radio Spectrum Matters and found the test results indeed meet the limitation of the relevant test standard(s) listed below: MPE SAR EN301489-1-3...
- Page 4 Warning Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 5 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
- Page 6 Giga-Tms will return the product, prepaid, via a three (3) day shipping service. A Return Material Authorization (“RMA”) number must accompany all returns.
- Page 7 THE SOLE REMEDY SHALL BE REPAIR OR REPLACEMENT AS PROVIDED ABOVE. GIGA-TMS’S LIABILITY, IF ANY, SHALL IN NO EVENT EXCEED THE TOTAL AMOUNT PAID TO GIGA-TMS UNDER THIS AGREEMENT. IN NO EVENT WILL GIGA-TMS BE LIABLE TO THE BUYER FOR ANY DAMAGES, INCLUDING...
-
Page 8: Table Of Contents
Contents Chapter 1 : Introduction.................9 Introduce.......................9 Chapter 2 ： About UHF880..............10 Specification.......................10 LED Indication....................11 Chapter 3 ： How to use UHF880............12 Before Installing....................12 Start to use UHF880...................12 Chapter 4 ： Interface connection............13 RS232 / Wiegand Model..................13 RS485 / Wiegand Model..................15 The ideal relative position of linear antenna and tag........19... -
Page 9: Chapter 1 : Introduction
Chapter 1 : Introduction Introduce The UHF880 include Antenna. It is all in one Ultra High Frequency RFID Reader compliant to ISO18000-6C EPC Gen 2 protocol with an operating range of 860 to 960 MHz. With UHF Tag which maximum read range can up to 5 meters. -
Page 10: Chapter 2 ： About Uhf880
Chapter 2 ： About UHF880 Specification UHF880 series EUROPE TAIWAN (865.7-867.5Mhz) (902.75-927.25Mhz) (920.25-927.75MHz) Model UHF880-30 UHF880-00 UHF880-40 Standard RFID spec ISO 18000-6C, EPC Class1 Gen2 Modulation type Amplitude-shift keying (ASK) Antenna type Patch antenna Interface Interface Wire – RS485/Wiegand 、 RS232/Wiegand Wireless - 1) 2.4GHz WIFI, 802.11 b/g/n... -
Page 11: Led Indication
LED Indication Status LED Status Green Blue Power on Blink Detect TAG Blink once Read TAG Blink once Wireless on Blink ... -
Page 12: Chapter 3 ： How To Use Uhf880
● The UHF880 use RS232/Wiegand and RS485/Wiegand to connect the PC or Controller. ● PC open UHF880 software to set up the UHF880. ● Please refer to UHF880 Software User Guide. There are instructions about how to read EPC Pin define . -
Page 13: Chapter 4 ： Interface Connection
RS232 / Wiegand Model ● Use RS232 to connection 1. UHF880 Reader is an all in one Reader. The Power (need for 12-24VDC) supply connected to UHF880 Reader 12-24VDC (Red wire) and Power GND (Grey wire). But before item 3. Don’t turn on the power. - Page 14 1. Before you start using Wiegand for connection. You must use RS232 to enter the software and set the device to Wiegand. 2. UHF880 Reader is an all in one Reader. The Power (need for 12-24VDC) supply connected to UHF880 Reader 12-24VDC (Red wire) and Power GND (Grey wire).
-
Page 15: Rs485 / Wiegand Model
RS485 / Wiegand Model ● Use RS485 to connection 1. UHF880 Reader is an all in one Reader. The Power (need for 12-24VDC) supply connected to UHF880 Reader 12-24VDC (Red wire) and Power GND (Grey wire). 2. PC or Controller need connect RS485 to UHF880 Reader I/O pins RS485- (Yellow wire) 、... - Page 16 1. Before you start using Wiegand for connection. You must use RS485 to enter the software and set the device to Wiegand.2. UHF880 Reader is an all in one Reader. The Power (need for 12-24VDC) supply connected to UHF880 Reader 12-24VDC (Red wire) and Power GND (Grey wire).
- Page 17 1. Before start to connect multiple UHF880 reader. Must use single RS485 to help each UHF880 set their Device ID (The default ID is 255. This can not be uses when more than one connection). The reason is avoid data to collisions and can send and receive data correctly.
- Page 18 8. When found UHF880 Reader. Software will display UHF880 Reader 9. Press the Auto mode button which start reading TAG information. 10. Put UHF TAG in front of UHF880 circularly polarized antenna within 5 meters. If properly read UHF TAG information. Tag EPC ID will show on software...
-
Page 19: The Ideal Relative Position Of Linear Antenna And Tag
The ideal relative position of linear antenna and tag... -
Page 20: Chapter 5 ： Troubleshooting
Chapter 5 ： Troubleshooting 1. Cannot connect to UHF880 with UHF880 software? ● Please check that the UHF880 is actually connected to 12-24VDC. ● Please check the power light (Green light) of UHF880 is lighting... -
Page 21: Contact Us
Contact Us Address: 8F, NO.31, Lane 169, Kang-Ning Street, His-Chih Dist, New Taipei City, Taiwan Tel: 886-2-26954214 Fax: 886-2-26954213 Websites: www.gigatms.com.tw Email: Sales inquiry email - promag@gigatms.com.tw After sales service - support@gigatms.com.tw...
Need help?
Do you have a question about the UHF880 and is the answer not in the manual?
Questions and answers