Download Print this page

Stanley HIDC10 Instruction Manual page 4

Compact high intensity discharge spotlight

Advertisement

Available languages

Available languages

There are no user-replaceable parts. Periodically inspect the condition of adapters, connectors and wires. Contact manufacturer to
replace any components that have become worn or broken.
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Contact manufacturer for any information you may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly. Recycling is
required, contact your local authority for information. Failure to comply with local, state and federal regulations can
result in fines, or imprisonment.
To locate a free recycling program collection center near you, go to www.call2recycle.org.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result
in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
12 volt DC charger plug fuse replacement
The fuse in the plug end of the 12 volt DC charger protects the adapter' s charging circuit. If the 120 volt AC charger operates, but the DC
charging adapter does not, then this fuse may be opened (blown).
To replace the fuse:
1. Unscrew the end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate a replacement 5 amp/250 volt fuse.
5. Replace the fuse, spring, contact and end cap.
6. Screw end cap clockwise until it is finger tight – DO NOT OVER-TIGHTEN.
7. Test for proper operation of the 12 Volt DC Charging Adapter.
TROUBLESHOOTING
The battery/charge status LED indicator does not flash when charging
1. Check connection to the AC-to-DC charging port.
2. Check connection to AC power source.
3. Confirm there is a functioning AC current.
Note:
The battery/charge status LED does not light or flash when the unit is charging using the DC charging method.
Unit will not operate
1. The spotlight will not operate when charging using the AC method. Be sure the AC charger is disconnected before spotlight use.
2. The battery may be completely discharged. Charge the unit following the directions in the .
3. If the spotlight does not operate after recharging as directed, contact manufacturer at (877) 571-2391.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need
assistance regarding accessories, please contact manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at (877) 571-2391.
ONE-YEAR LIMITED WARRANTY
Manufacturer warrants this product for one year against any defects in material or workmanship. The defective product will be
replaced or repaired at no charge in either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased (provided that the
store is a participating retailer). Returns should be made within the time period of the retailer' s policy for exchanges (usually 30 to
90 days after the sale). Proof of purchase may be required. Please check with the retailer for their specific return policy regarding
returns that are beyond the time set for exchanges. The second option is to return the product (prepaid) to the manufacturer for
repair or replacement at our option. Proof of purchase may be required.
This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other rights which vary
from state to state or province to province. This product is not intended for commercial use.
6
SPECIFICATIONS
Spotlight bulb:
20 watt HID bulb
Battery:
Maintenance-free, sealed lead acid, 12 volt, 1.2 Ah
AC charger:
UL Listed Class 2, 12 volt DC (500 mA)
DC charger plug fuse:
5 A/250 V
Imported by
Baccus Global
595 S. Federal Highway, Suite 210
Boca Raton, FL 33432
(877) 571-2391
RD090910
7

Advertisement

loading

This manual is also suitable for:

Hidc10l