Sensofresh Î; Starching; Dyeing/Bleaching; Soaking - Siemens WM14W790AU Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Overview of programmes
en
sensoFresh î
sensoFresh î is an innovative
programme that is designed to refresh
laundry and remove odours (e.g. the
smell of cigarettes and kitchen odours).
Sweaty fabrics must be washed.
In this programme, your laundry is
treated with active oxygen and water
mist; detergent is not added.
Active oxygen is a special type of
oxygen which effectively reduces
odours.
The programme is suitable for all types
of material and fabric, even for those
which should only be professionally
cleaned.
Once the programme has started, the
drum inside the appliance lights up and
the mist that is created can be seen.
Once the programme has finished, take
the laundry out of the drum and shake it
out briefly.
Notes
Leave the door and detergent
drawer open slightly when the
appliance is not in use. ~ Page 44
The active oxygen treatment is less
effective if the drum is dirty. Run the
Drum Clean î programme
regularly.
It is not possible to add laundry once
the programme has started.
If you cancel the programme or
switch to a different one, the door
will remain locked until there is no
longer any active oxygen in the
drum. This make take up to
25 minutes. The two symbols Ï and
î will flash during this time. The
door will then unlock automatically.
34

Starching

Laundry should not be treated
Note:
with fabric softener.
Liquid starch can be used to stiffen
fabrics particularly in the Rinse and
Cottons programmes. Measure starch
into compartment M in accordance with
the manufacturer's instructions (clean
first if necessary).

Dyeing/bleaching

Dye should only be used in normal
household quantities. Salt may damage
stainless steel. Always follow the dye
manufacturer's instructions.
Do not use the washing machine to
bleach clothes.

Soaking

Switch on the appliance.
1.
Select the Cottons 30 °C
2.
programme.
Pour soaking agent/detergent into
3.
compartment II in accordance with
the manufacturer's instructions.
Press the Ü button. The programme
4.
starts.
After approx. 10 minutes, press the
5.
Ü button to pause the programme.
Leave the laundry to soak for as long
6.
as required, then either press the Ü
button again to continue the
programme or change the
programme.
Notes
Load laundry of the same colour.
No additional detergent is required;
the soaking solution is used for
washing.

Advertisement

Table of Contents
loading

Table of Contents