StealthTronic 3G User Manual

1

Start up

st
1. Insert the nano-simcard, connect the battery and wait for 1
minute for the device to bootup.
2. Call the unit and let is pick up your number.
3. When sending commands to the unit, always wait for about
10 – 20 seconds before the unit will send you the command.
It's important to have the SMS activated with "SMS1"
Commands:  - variable
Name Command
Voice detection
VOX
Voice during phone
call (Gain)
Sensitivity for VOX
SENS
detection
VOX sensitivity
VOXSENS
hangs up the phone.
Battery status BAT
Ultra-Sleep Mode
SLP
(for most battery life)
Factory settings RESET
Status of device STATUS
Password settings PASSWORD
Setting a master SETCALLNUM+420777123456 OR
number SETCALLNUM777123456
Deleting a master
DELCALLNUM
number
Activate Phone call
when password is on.
Turn OFF led diode LED
www.stealthtronic.com | sales@stealthtronic.com
3G listening unit
Command values
0 - OFF 1- ON
0 - OFF
1 - highest
199- lowest
0 - OFF
1 - highest
199- lowest
0- OFF
1 - 1 hour sleep mode
24 - 24 hours sleep mode
000 - No password
001 to 999 - possible number com-
bination for passwords
ex: 777 - Password is set to 777
Choose your password, it always
has to be 3 digits
0 – OFF
1 - ON
Description
(send SMS VOX1 or VOX0) to activate or deactivate.
Simply, for increasing the signal from the microphone, you
use following commands, pressing on the keypad: #01,
#02, to #09 ... wait in between the pressing of DTMF tone.
The higher the number the more noise is needed to acti-
vate. We recommend about 30 for human voice.
This command will hang up an already dialed phone call,
if the noise does not go over a set threshold. The interval
is 2 minutes.
This function is useful especially when you have a recor-
ding station, and you are not listening to the unit directly.
It will save you hours of silent recording.
Returns percentage of battery
You need to activate VOX before, if you don't, the unit will
not wake up, even when there is a noise.
Else the unit is in Ultra Sleep Mode, when it will wake up
in set intervals.
For example, SLP3 means that every 3 hours the unit will
wake up. If you wish to turn this function off, you have to
send SLP0 to the unit.
Factory settings = SLP0, VOX0, VOXSENS0, SENS50
The device will send you a status report, about all the
commands, battery and signal strength.
If you decide to activate password you will have to use it
for further communication with the device.
For example, if you set PASSWORD777 and you will want
to change the sensitivity you will need to
do so like this 777SENS50
Its advised to use the international format for setting the
number for the 3G unit.
This command will erase a master phone number.
If the PASSWORD is on and you will dial the device, you
have to punch in the combination 777 to activate the
microphone.
user manual