Fine Tuning A Pitch (Tuning - Casio CDP-S110 User Manual

■ To use a value to specify the transpose setting
• While the setting value is within the range of 0 to +12
semitones, you can use the procedure below to directly
input a desired setting value.
1.
While holding down 3 FUNCTION, perform
steps (1) and (2) below.
(1) Press the TRANSPOSE– keyboard key (F5) or the
TRANSPOSE+ keyboard key (F{5).
(2) Use the [0] (E4) through [9] (C{5) keyboard keys to
input a two-digit transpose value.
For example, to specify a setting 8 semitones, press
keyboard keys in the following sequence: [0] (E4) 3
[8] (C5). Inputting the second and final digit will
cause a short and then long beep to sound,
indicating that the value you input was applied.
2.
Release 3 FUNCTION.

Fine Tuning a Pitch (Tuning)

The tuning feature specifies the frequency of the A4 note. You
can set a frequency within the range of 415.5 to 465.9 Hz. The
initial default setting is 440.0 Hz.
The setting you configure is retained even if you turn off the
Digital Piano.
C1 C2 C3
2 4
0 1 3
[0] (E4) to [9] (C{5) keys
[+] key (E}4)
[–] key (D4)
■ To change the tuning setting
1.
While holding down 3 FUNCTION, perform
steps (1) through (3) below.
• If a key operation during steps (1) through (3) would cause
the setting to exceed its upper or lower maximum limit, a
high and then low beep will sound to indicate that the
setting cannot be changed further.
(1) Press the TUNE– keyboard key (G5) or the TUNE+
keyboard key (A}5).
• Pressing the TUNE– key (G5) will lower the
current pitch setting by 0.1 Hz, while pressing
TUNE+ (A}5) will raise it by 0.1 Hz.
• If you just want to fine tune the current pitch
setting, go directly to step (3) below.
Configuring Settings
C4 C5 C6 C7
6 9
5 7 8
TUNE– key (G5)
TUNE+ key (A}5)
C8
EN-13