Toshiba MV9DL2 Service Manual page 15

2-18: CLUTCH ASS'Y (Refer to Fig. 2-18)
1. Remove the Capstan Brake Spring.
Remove the Polyslider Washer 1.
2.
3. Remove the Clutch Ass'y, Ring Spring and Coupling
Gear.
Unlock the 2 supports 2 and remove the Clutch Lever.
4.
1
Clutch Ass'y
Ring Spring
Coupling Gear
2
Clutch Lever
2
2-19: LOADING GEAR S/T ASS'Y (Refer to Fig. 2-19-A)
Remove the E-Ring 1 and remove the Main Loading
1.
Gear.
2. Slide the Main Rod and remove the Spring Holder.
3. Remove the Main Rod, Tension Lever, Clutch Actuator,
Idler Arm Ass'y.
Remove the screw 2.
4.
Remove the LED Reflector.
5.
Remove the Loading Arm S Ass'y and Loading Arm T
6.
Ass'y.
Remove the Loading Gear S and Loading Gear T.
7.
8. Remove the Loading Gear Spring.
Spring Holder
Main Rod
Idler Arm Ass'y
2
LED Reflector
Clutch Actuator
• Screw Torque: 5 ± 0.5kgf•cm
All manuals and user guides at all-guides.com
DISASSEMBLY INSTRUCTIONS
Capstan Brake Spring
Fig. 2-18
1
Main Loading Gear
Tension Lever
Loading Gear T
Loading Gear
Spring
Loading Arm T Ass'y
Loading Gear S
Loading Gear
Spring
Loading Arm S Ass'y
Fig. 2-19-A
B2-5
NOTES
1. When you install the Loading Arm S Ass'y, Loading Arm
T Ass'y and Main Loading Gear, align each marker.
(Refer to Fig. 2-19-B)
Main Loading Gear
Marker
Loading Arm T Ass'y
2. When you install the Clutch Actuator, install as shown in
the circle of Fig. 2-19-C. (Refer to Fig. 2-19-C)
Clutch Actuator
2-20: INCLINED S/T ASS'Y (Refer to Fig. 2-20)
1. Remove the Cap P4.
Remove the screw 1.
2.
Unlock the support 2 and remove the Loading Gear
3.
Holder.
4. Remove the Inclined S Unit.
5. Remove the Inclined T Unit.
NOTE
Do not touch the roller of Guide Roller.
Inclined Base
S Unit
• Screw Torque: 2.5 ± 0.5kgf•cm
Marker
Loading Arm S Ass'y
Fig. 2-19-B
Fig. 2-19-C
1
Loading Gear Holder
2
Inclined Base T
Unit
Cap P4
Fig. 2-20