4 Use your TV
Switching on your TV and putting it in Standby
mode
TV
Remote Control
To Turn the TV On from Standby or Off to Standby
Press B on the Side panel or the Remote Control.
●
Note(s)
Energy Consumption contributes to air and water pollution. When the AC Power Cord
●
is plugged in, your TV consumes energy with a very low Standby Power Consumption.
Adjusting Volume
TV
Remote Control
To decrease or increase Volume
Press VOL J / K on the Side panel or press VOL + / – on the Remote
●
Control.
VOL J (–) : Volume Down
VOL K (+) : Volume Up
To mute or unmute sound
Press D on the Remote Control to Mute the sound.
●
Press D again on the Remote Control or VOL + / – to recover the
●
original sound.
Switching Channels
TV
Remote Control
To Select Channels by using CH H / I or CH + / –
Press CH H (Up) / I (Down) on the side panel or press CH + / – on
●
the Remote Control.
To Select Channels by using the NUMBER buttons
Digital TV Operation
For Digital channels, press a number followed by a dot "•" and the
●
corresponding sub channel number.
When selecting Digital channel 11.1
–
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
When selecting Cable or Analog channel 11
–
Press PREV.CH to return to the previously viewed channel.
Note(s)
To Select the non-memorized channels, use the NUMBER buttons.
●
Channel not available or No signal will appear on the TV screen after the subchannel
●
broadcast is over.
Audio only message will appear on the TV screen, when you receive only sound signal.
●
20
.
English
Continued on next page.