JL Audio DOMINION d110 Owner's Manual page 22

STEREO RECEIVER
SPEAKER
OUTPUTS
+ +
– L – R
(L) (R)
TO SATELLITE
SPEAKERS
STEREO RECEIVER
SPEAKER
OUTPUTS
– L + – R +
WARNING! TURN OFF THE DOMINION™(s) AND ALL OTHER EQUIPMENT
IN THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
Page 22
DOMINION™ REAR PANEL
OR OR
DOMINION™ REAR PANEL
SYSTEM CONNECTION DIAGRAM 5:
Connecting one Dominion™ to a
Receiver via the Speaker Level Inputs
The Dominion™ features speaker level
inputs designed to accept the output of an
amplified source, such as a stereo receiver's
speaker outputs. The use of this feature is
only recommended when no suitable line-
level signal is available.
HIGH LEVEL
When connecting a single Dominion™
INPUT PLUG
in mono to a two-channel receiver's speaker
CH. 1 CH. 2
(L) (R)
outputs, you will use both the Left and
Right connections on the "Speaker Level"
inputs plug of the Dominion™. Use good-
quality speaker cables (up to 12 AWG / 3
mm 2 ) to make these connections. Make
sure you capture all the wire strands in
each connector port and do not allow any
of these wires to short together.
You can make the connections to
the Dominion™ subwoofer's inputs at
the receiver's output terminals, or at
the main speakers, whichever is more
convenient. On receivers with A/B speaker
circuit selectors, you can connect the
Dominion™ to the "B" outputs, giving
you the ability to easily switch the
subwoofer's signal on and off with the
receiver's speaker circuit selector switch.
The input section of your Dominion™
TO SATELLITE
SPEAKERS
will sum the left and right inputs to mono
and apply low-pass filtering to feed the
(R) (L)
subwoofer's internal amplifier when the "LP
Filter" of your Dominion™ is switched "on."
Because the main speakers are being
HIGH LEVEL
INPUT PLUG
fed in parallel with the inputs of the
Dominion™, they continue to operate as
CH. 1 CH. 2
(L) (R)
full-range speakers. Any adjustment of the
"LP frequency (Hz)" knob will only affect
the sound of the Dominion™, not the
main speakers.
WARNING
| d108 & d110