Adjusting The Stand Height; Using The Kensington Locking Device - LG 27MB35PH Owner's Manual

Adjusting the stand height

1
Place the monitor mounted on the stand base
in an upright position.
2
Remove the tape attached at the bottom rear
of the stand body, then pull out the locking
pin.
23MB35PH
Stand Body
Tape
24MB35PH 27MB35PH
Stand Body
23MB35PH
3
24MB35PH
The height can be adjusted up to 110 mm.
27MB35PH
The height can be adjusted up to 130 mm.
CAUTION
Once the pin is removed, it is not necessary
y
to re-insert it to adjust the height.
Locking Pin
Tape
Locking Pin
110.0mm
130.0mm
ASSEMBLING AND PREPARING
WARNING
Do not put your finger be-
y
tween the screen and the
base (chassis) when adjust-
ing the screen's height.
Using the Kensington locking
device
The connector for the Kensington lock is located
on the rear of the monitor.
For more information on installation and usage,
refer to the Kensington lock user manual or visit
the website at http://www.kensington.com.
Connect the monitor to the table with the Kensing-
ton lock cable.
23MB35PH
24MB35PH
27MB35PH
NOTE
Using the Kensington lock is optional. The
y
accessories can be purchased at your local
electronics store.
13