Electrical; Electrical Requirements; Fitting A Different Plug - Beko CDA751F Installation, Operating & Food Storage Instructions

electrical

Electrical requirements

Before you insert the plug into the wall socket make sure that the
voltage and the frequency shown in the rating label, which is on the
left hand side of the fridge inner liner corresponds to your electricity
supply.
We recommend that this appliance be connected to the mains supply
via a suitable switched and fused socket. The appliance must be
positioned so that the plug is accessible.
Should the mains lead of the appliance become damaged or need
replacing at any time, it must be replaced by a special purpose made
mains lead which can only be obtained from a Beko Authorized Service
Agent.
Warning
This appliance must be earthed
If the fitted moulded plug is not suitable for your socket, then the
plug should be cut off and an appropriate plug fitted.
Destroy the old plug, which is cut off as a plug with a bared cord could
cause a shock hazard if inserted into a socket elsewhere in the house.
The moulded plug on this appliance incorporates a 13A fuse. Should
the fuse need to be replaced an ASTABEAB approved BS1362 fuse of
the same rating must be used. Do not forget to refit the fuse cover. In
the event of losing the fuse cover, the plug must not be used until a
replacement fuse cover has been fitted. Colour of the replacement fuse
cover must be the same colour as that visible on the pin face of the
plug. Fuse covers are available from any good electrical store.
Important

Fitting a different plug

As the colours of the wires in the mains lead of this appliance may
not correspond with the coloured markings identifying the terminals
on your plug, proceed as follows:
1 Connect the green - yellow or green (earth) wire to the terminal in
the plug marked 'E' or with the symbol
yellow or green.
2 Connect the blue (neutral) wire to the terminal in the plug marked
'N' or coloured black.
3 Connect the brown (live) wire to the terminal in the plug marked 'L'
or coloured red.
With the alternative plugs a 13A fuse must be fitted either in the
plug or adaptor or in the main fuse box. If in doubt contact a qualified
electrician.
4
or coloured green and
Green and yellow
or green
N
Blue or
black
L
Brown or
red