Table of Contents
Advertisement
en Home Connect
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡ Press Start/Reload
¡ Open the door.
¡ Switch off the appliance.
¡ Power failure.
Activating Wi-Fi on the appli-
ance
Note: When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press Start/Reload
3.
until the display shows On.
a Wi-Fi is activated.
Note: If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
Deactivating Wi-Fi on the ap-
pliance
Press and hold Remote Start
1.
at least three seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press Start/Reload
3.
until the display shows OFF.
a Wi-Fi is deactivated.
Note: If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
Software update
Requirement: The display shows
Upd.
44
.
for
repeatedly
for
repeatedly
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 6.
2.
a UdP appears on the display.
Press Start/Reload
3.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note: The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
Resetting the appliance net-
work settings
Press and hold Remote Start
1.
at least 3 seconds.
Set the programme to position 5.
2.
a The display shows rES.
Press Start/Reload
3.
a The display shows YES.
Press Start/Reload
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
Tip: If you wish to operate your appli-
ance again via the Home Connect
app, you will need to reconnect it to
the Wi-Fi and to the Home Connect
app.
Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the Home Con-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip: For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
for
.
for
.
.
Advertisement
Table of Contents
