Advertisement
JT6200M Outdoor CPE
User Manual V1.0
Jaton Technology Limited. C
ONFIDENTIAL
This document and the information contained in it is confidential information of Jaton Technology Limited (Jaton), and
shall not be used, or publish, or disclosed, or disseminated outside of Jaton in whole or in part without Jaton's consent.
This document contains trade secrets of Jaton. Reverse engineering of any or all of the information in document is
prohibited. The copyright notice does not imply publication of this document
© C
2016, Jaton Technology Limited.
OPYRIGHT 2007-
CONFIDENTIAL INFORMATION
Information contained herein is proprietary to Jaton for whose benefit
Confidentiality shall be maintained
Advertisement
Table of Contents
Summary of Contents for Jatontec JT6200M
- Page 1 JT6200M Outdoor CPE User Manual V1.0 Jaton Technology Limited. C ONFIDENTIAL This document and the information contained in it is confidential information of Jaton Technology Limited (Jaton), and shall not be used, or publish, or disclosed, or disseminated outside of Jaton in whole or in part without Jaton’s consent.
-
Page 2: Getting To Know Your Device
Getting to Know Your Device Packing list Upon receiving the product, please unpack the product package carefully. Each product is the following items: shipped with CPE Products Quantity ODU unit Router unit Mounting brackets 48V DC power adapter Ethernet cable If you find any of the items is missing, please contact our local distributor immediately. -
Page 3: Connection Scenario
To use the phone service, user can simply plug the phone line to the CPE RJ11 port in the back. If the line is not registered or configured, a fast busy tone will be provided and the corresponding LINE LED light will be off (the ROUTER Only). www.jatontec.com... - Page 4 To obtain the best radio signal level and connection quality, the user can rotate the CPE slowly in horizon direction to find the best signal direction, then fixed it with the anchor ear. The CPE radio signal strength level can be observed from the RF LEDs mounted on the lower panel as shown below.
-
Page 5: Connecting To Your Device
It is a preferred to setup the CPE using a Web browser from a local PC connected to device LAN port. The user should ensure that the connected PC have acquired IP address via DHCP from the device. After IP connectivity is established between the PC and CPE device, the user may www.jatontec.com... - Page 6 launch a Web browser and specify http://172.16.1.1 in the address bar. A window will pop up requesting password. Input the user login password and then click the “Log in” button. After successful log on, the default home page of the WEB GUI interface will appear. Note that the default user password is “user123”.
- Page 7 After factory reset, the device may need to be reconfigured by the user or even operator to gain network access. This is not a recommended operation and special care must be taken to ensure the device will be properly re-configured after factory reset. www.jatontec.com...
-
Page 8: Faq And Troubleshooting
FAQ and Troubleshooting Problem Suggested Solution Re-plug the PC Ethernet cable and check if the PC LAN • connection is up or showing activity. Check if the system run LED is on. If it is not, check the • My PC cannot connect to power cord and make sure it is connected properly.
Need help?
Do you have a question about the JT6200M and is the answer not in the manual?
Questions and answers