Advertisement
►
Instructions:
1.
Place the face frame (A) face down on a flat soft working surface to ensure that the face is
not scratched or damaged (Figure 1).
2.
Installing the Side Panels (Figure 2): Insert right and left side panels (B) into the grooves
of the face frame (A) and align the cam lock connectors (Figure 2). Lock the cam with a
screwdriver by turning the screw 180° degrees clockwise (Figure 4).
3.
Installing the Bottom (Figure 3): Gently spread the side panels and insert the bottom (C)
into the grooves of side panel (B) until it touches the face frame (A). Align it and lock each cam.
4.
Installing the Back Panel and Toe Kick (Figure 5): Before you start this step, put the
back panel (E) on a flat surface facing upward. Install the drawer rail holders (L) in the pre-
spotted area on the back panel (Figure 6). The opening of the holders should be facing towards
each other. Secure them with 2 round head screws Figure 6).
at rear of side panel (B) (Figure 5). Align and lock each cam lock. Install the Toe Kick (G) by
locking the cam lock at both ends (Figure 5).
5.
Installing the Drawer Slide Rails:
holder (L) previously installed (Step 4) on the back panel. Then secure the drawer rail front end
with 1/2" screws using the pre-drilled holes in the face frame. (Repeat this step for more
drawers.).
6.
Drawer Assembly (Figure 7):
the assembled drawer box(I) to the drawer front(H) using 1" flat head screws.(Repeat this step for
more drawers).
H
8.
Installing the Corner Braces (Figure 8) and inserting the Drawers: Place the corner
braces (K) on each top corner of the cabinet and secure them with the ½" Corner Brace Screws.
Slide the drawers into the rail and check the drawer position and adjust slide rail location for
best operation if necessary. The 2" screws are used for connecting corner braces and the
counter top.
Insert the drawer side rails backend into the
Place the drawer front(H), face down on a flat surface, install
I
7
8
Page 3
Then put the back panel (E)
A
Figure 1
E
G
L
L
E
Advertisement
