Table of Contents
Advertisement
●
When you recompose shots, the
focus, brightness, and colors will be
automatically adjusted.
3) Finish recording.
●
Press the movie button again to stop
recording. The camera beeps twice as
recording stops.
●
Recording will stop automatically when
the memory card becomes full.
Still Images/Movies
●
If the camera makes no operating sounds, it may have been
turned on while holding down the [
sounds, press the [
] button, choose [Mute] on the [
tab, and then press the [ ][ ] buttons to choose [Off].
Still Images
●
A blinking [
] icon warns that images are more likely to be
blurred by camera shake. In this case, mount the camera on a
tripod or take other measures to keep it still.
●
If your shots are dark despite the flash firing, move closer to the
subject. For details on the flash range, see "Flash" ( = 138).
●
The subject may be too close if the camera only beeps once
when you press the shutter button halfway. For details on the
range of focus (shooting range), see "Shooting Range (measured
from the tip of the lens)" ( = 138).
●
To reduce red-eye and to assist in focusing, the lamp may be lit
when shooting in low-light conditions.
●
A blinking [ ] icon displayed when you attempt to shoot
indicates that shooting is not possible until the flash has finished
recharging. Shooting can resume as soon as the flash is ready,
so either press the shutter button all the way down and wait, or
release it and press it again.
●
Although you can shoot again before the shooting screen
is displayed, your previous shot may determine the focus,
brightness, and colors used.
Movies
] button. To activate
]
●
You can change how long images are displayed after shots
( = 40).
●
Before shooting a movie, lower the flash with your finger.
Be careful not to touch the microphone (1) when shooting a
movie. Leaving the flash raised, or blocking the microphone may
prevent audio from being recorded or may cause the recording to
sound muffled.
( 1 )
●
Avoid touching camera controls other than the movie button when
recording movies, because sounds made by the camera will be
recorded.
●
Once movie recording begins, the image display area changes
and subjects are enlarged to allow for correction of significant
camera shake. To shoot subjects at the same size shown before
shooting, adjust the image stabilization setting ( = 59).
●
Audio recording is monaural.
Before Use
Basic Guide
Advanced Guide
1
Camera Basics
2
Auto Mode
3
Other Shooting Modes
4
P Mode
5
Playback Mode
6
Wi-Fi Functions
7
Setting Menu
8
Accessories
9
Appendix
Index
31
Advertisement
Table of Contents
