Electrolux UK1205S User Manual page 57

Problem
The compressor operates
continually.
There is too much frost
and ice.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig‐
erator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Temperature is set incor‐
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
ENGLISH
Solution
Refer to "Operation" chap‐
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drain‐
age plug in the correct
way.
Wrap the food products
better.
Refer to "Operation" chap‐
ter.
This is correct.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
57