Download Print this page

Removing The Rechargeable Battery; Warranty And Support; Troubleshooting - Philips BT7220 Manual

Advertisement

Recycling
- Do not throw away the product with the normal
household waste at the end of its life, but hand
it in at an official collection point for recycling.
By doing this, you help to preserve the
environment.
- This product contains a built-in rechargeable
battery which shall not be disposed of with
normal household waste. We strongly advise
you to take your product to an official collection
point or a Philips service centre to have a
professional remove the rechargeable battery.
- Follow your country's rules for the separate
collection of electrical and electronic products
and rechargeable batteries. Correct disposal
helps prevent negative consequences for the
environment and human health.

Removing the rechargeable battery

Only remove the rechargeable battery when
you discard the appliance. Before you remove
the battery, make sure that the appliance is
disconnected from the wall socket and that
the battery is completely empty.
Take any necessary safety precautions when
you handle tools to open the appliance and
when you dispose of the rechargeable battery.
1
Check if there are screws in the back or front of
the appliance. If so, remove them.
2 Remove the back and/or front panel of the
appliance with a screwdriver. If necessary, also
remove additional screws and/or parts until you
see the printed circuit board with the
rechargeable battery.
3 Remove the rechargeable battery.

Warranty and support

If you need information or support, please visit
www.philips.com/support or read the
international warranty leaflet.

Troubleshooting

This chapter summarizes the most common
problems you could encounter with the product. If
you are unable to solve the problem with the
information below, visit www.philips.com/support
for a list of frequently asked questions or contact
the Consumer Care Center in your country.
Problem
The
appliance
does not
work.
I cannot
switch off
the vacuum
system.
The vacuum
system
performs
poorly or
does not
work at all.
简体中文
一般说明(图 1)
1 修剪部件
2 真空系统
3 长度设定
4 调节轮
5 开/关按钮
6 电池状态指示灯
7 存储袋
8 清洁刷
9 清洁海绵
10 小插头
11 电源部件
Possible
cause
The battery is
empty.
The vacuum
system is
automatically
deactivated
when the
appliance is
switched off.
It is activated
automatically
as soon as
you switch on
the
appliance.
The hair
chamber is
full.
The air holes
on the
appliance are
covered. If
they are,
vacuum
performance
is reduced.
Solution
Charge the
appliance for at
least 2 hours so the
appliance has
enough power
again.
Switch off the
appliance.
Empty the hair
chamber after each
trimming session.
First remove the
cutter from the
appliance, then
empty the hair
chamber by
carefully shaking or
blowing hair out
and/or by brushing
the hair out with
the cleaning brush
or cleaning sponge
supplied. Never
use water to clean
the hair chamber,
this may damage
the appliance.
Make sure the air
holes on the
appliance are not
covered.
If the suction
system performs
poorly or not at all,
even though the
appliance is clean,
not covered and
used according to
the instructions in
the user manual,
take the appliance
to your local
Philips dealer or
call the Consumer
Care Center.

Advertisement

loading