Table of Contents
Advertisement
2. 3 Calibration
If your scooter seems to pull to the left or right, you may need to recalibrate its sensors. The process requires two levels, available
at any hardware store. Many smartphones have free "bubble level" apps as well.
Step 1: Power off the scooter.
Step 2: Place each level parallel with the wheel touching the inside of the wheel base.
Step 3: Rotate the scooter until both levels on each wheel base are level. If you do not have a level, make
sure both platforms are equal with each other and level to the ground as best as possible.
Step 4: While keeping the scooter level, hold the power button down. The scooter will make the normal power on tone. Wait 3
seconds and you will hear a single beep. Release the power button. Front LEDs will begin flashing. Power the scooter off.
Step 5: Power on again. The scooter should now be calibrated. If the scooter is still not
calibrated correctly, go to step 1 and begin making minor adjustments.
GS36BC-v1536-IB.indd 8
- 8 -
12/14/2015 2:02:15 PM
Advertisement
Table of Contents
