Table of Contents
Advertisement
RS232 DC Power Outlet
- It is a mode to decide whether to output DC or not for power supply to IB Box in Installation Menu. We offer a output
terminal in one Pin of RS232C Jack for the use of communication.
- 5 V DC Power Outlet and 12 V DC Power Outlet must operate mutually exclusively. That is, only one of the two sides must be
turned on.
► You can select 'OFF' , '5 V' or '12 V' by pressing ^ button.
• When select '5 V' the 5 V is forwarded through the port. when select '12 V' the 12 V is forwarded through the port.
•
• Type of Connector: D-Sub 9-Pin Male
•
1
6
Male connector on box, viewed
towards connector.
One Channel Map
- If 'One Channel Map' is 'Enable' , the TV will operate as below.
• A. When the TV is auto-scanning, it searches both air and cable channels.
•
• B. User can assign a channel number him/herself by manual scan.
•
• C. In 'Programme Edit' window, all channels are shown in a single list regardless of input source.
•
• D. Automatically scanned channels may not have the user-desired channel numbers.
•
- If user change the 'Enable/Disable' value, an pop-up window will be displayed to warn that all channel
information will be deleted. The Default value is 'Enable' .
RS-232C IN
(CONTROL & SERVICE)
No.
5
1
2
3
4
5
9
6, 8
7
9
INSTALLATION MENU
Interface box
Signal
Signal requirements
VCC
RX RS232
Standard RS232 specification
TX RS232
Standard RS232 specification
IR from TV
GND
Power ground
Not connected
2 A
+5VDC 10%, max 100mV ripple
1.5 A
+12VDC 10%, max 100mV ripple
25
Advertisement
Table of Contents
