Advertisement
Quick Links
2017
User's manual
v1.1
SAFETECH
ST80
Please read this manual before first use.
O p a l e - P a r a c h u t e s . c o m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
contact@opale-aerosystem.com +33(0)981 144 387
© Copyright 2016 - Opale Aerosystem SARL - Tous droits réservés
Advertisement
Summary of Contents for Opale Parachutes SAFETECH ST80
- Page 1 2017 User’s manual v1.1 SAFETECH ST80 Please read this manual before first use. O p a l e - P a r a c h u t e s . c o m Opale Aero System SARL - 23 rue de la Motte 62250 MARQUISE - France contact@opale-aerosystem.com +33(0)981 144 387 ©...
-
Page 2: Composition Of The Kit
Thank you for choosing Opale-Parachutes. Composition of the kit This user’s guide includes all the information you need to assemble and use your parachute rescue kit. A good knowledge of your equipment will allow you to safely obtain most of its performances .Thanks for giving this manual to the new owner in case you decided to sell your kit. - Page 3 Sink rate / impact energy characteristics according to the drone mass (approximate value): Assembling 2.5m2 Hemispheric parachute: Total mass (kg) Install 2 CHC M3x12 screws with M3 nuts. Falling speed(m/s) Impact energy (J) 3m2 Cross parachute: Total Mass (kg) Sink rate (m/s) Impact energy (J) Place the servomotor.
- Page 4 Assembling Assembling Attach the line provided to the tube base by passing Pass the line through the piston. the line through the loop. Take out the other end of the line on the opposit side. Prepare 1 CHC M3x8 with a large M3 washer. Arrange the line loop on the screw, as shown on the picture.
- Page 5 Assembling Parachute preparation and installation The arming rod has to stand out at the base of the Remove the black tether strap of the rescue para- tube.. chute. Replace it with the Aramid strap provided. Cut with a pair of scissors the connecting line. Re- move what’s remain of the line on the parachute.
- Page 6 Parachute preparation and installation Parachute preparation and installation Once again equally arrange the panels to the left and Arrange the parachute inside the tube, and make right. sure that the lines and the parachute trailing edge With the first half, do a simple S. And hold those panels are placed upwards the tube.
- Page 7 Parachute preparation and installation Transmitter / module setting Slide the 8 on top of the parachute. In locking status the piston is locked with the pin. The servomotor horn can have an angle from 45 to 70° (the angle formed by the servomotor plan and the horn).
-
Page 8: Maintenance
These operations can be done at our workshop. Make sure that you have the same servo settings on Please contact your Opale Parachutes team. both ST80. You will be able to use a Y power cable to simultaneously deploy both parachutes. - Page 9 Flat view O p a l e - P a r a c h u t e s . c o m Opale Aero System SARL - 23 rue de la Motte 62250 MARQUISE - France contact@opale-aerosystem.com +33(0)981 144 387 ©...