Table of Contents
Advertisement
User Manual:
Safety Instructions
Installation Instructions
POWER SOURCE AND GROUNDING
→
It's recommended to use the vertical freezer on it's own dedicated power outlet for both convenience
→
and safety. The power outlet must be grounded.
Important!
→
LOCATION
→
When selecting a position for the vertical freezer, ensure that the oor is rm, at and level, along
with the room being well ventilated. Avoid locating the appliance near a heat source (ie. heater, oven
or boiler). Also avoid direct sunlight as it may increase the electrical consumption and/or e ect the
freezer's performance. This appliance is not designed for use within a garage or an outdoor installation.
Do not drape the appliance with any covering.
When installing the appliance, ensure that 10cm of free space is left on either side, 10cm of space at the
rear and at least 30cm of free space above. This will allow cold air to circulate around the freezer and
improve the e ciency of the freezing process.
→
REVERSING THE DOOR SWING
Tools Required: Phillips Head screwdriver/ Flat Head screwdriver/ Hexagonal spanner.
1.
→
2.
→
3.
Your InAlto Vertical Freezer
4.
5.
If the power cord is damaged, it must be replaced by Residentia Group or one of it's
authorised service representatives. Please contact 1300 11 HELP (4357) and ensure the
appliance is completely disconnected from the power supply.
Remove the top right hinge cover.
Remove the screws that x the top hinge into place, using the Phillips Head screwdriver.
On the removed top door hinge, remove the nut with sleeve and swap the pivot to the
other side of the hinge bracket (as shown below).
This hinge will be xed into place on the other (top) side of the freezer, as the last step
(NOT YET).
Remove the door limit block from the top of the door and move to the other side of the
door (as shown below).
Page:
5
Advertisement
Table of Contents
