Bauhn AMAB-0621-S Installation Manual

Have you got everything?
J
K
Unpack the box (be gentle) and make sure all of these items are there:
A. Gas Spring Monitor
Bracket with USB ports
B. Bracket Clamp
C. M4 x 8mm Screws (4)
1
2
3
Attach to your desk
(mounting to desk cable opening)
Loosen the two screws that connect the two parts of
the clamp.
Put the arm through the hole in your table.
Install the lower part of the
clamp with the two screws.
Tighten the clamp until it is
securely fastened to the desk.
Installation Guide
Gas Spring Monitor Bracket
Hey!
Let's get your new monitor
bracket ready to use, fast!
x 4
H
D. M4 x 12mm Screws (4)
E. Screw Spacers (4)
F. 4mm Hex Key
G. 5mm Hex Key
Attach the bracket clamp to the base with the 3 cap
Adhere the bracket cover and the bracket clamp
cover to the support block of the bracket clamp.
Tighten the securing bracket by turning the
adjuster clockwise and make sure it's tight.
If your desk is too thick, adjust the clamp
Be careful not to overtighten the clamp or you Be careful not to overtighten the clamp or you
might cause surface damage to your desk or table might cause surface damage to your desk or table
Model: AMAB-0621-S
with USB ports
x 4
x 4
F
I
x 3
L M
H. Cap Screws (3)
I. Bracket Clamp Cover
J. Bracket Cover
K. Cable Cover
Attach to your desk
(Mounting to edge of desk)
screws. Use the 4mm hex key to tighten.
down a notch and re-tighten.
You will also need
a Phillips-head
screwdriver
to secure your
monitors to the
bracket
N
L. Warranty Certificate
M. General Safety Warnings
N. Installation Guide
1
3
Nearly done!
Just a bit more
on the other side
of this page...
2