Table of Contents
Advertisement
EN G LI SH
Dust Extraction (fig. 9)
A dust extraction port (u) is supplied with your tool.
• Always use a vacuum extractor designed
in compliance with the applicable Directives
regarding dust emission when sawing wood.
Vacuum hoses of most common vacuum
cleaners will fit directly into the dust extraction
spout.
TO INSTALL DUST EXTRACTION PORT (FIG. 9)
1. Fully loosen depth adjustment lever (d).
2. Place shoe (e) in the lowest position.
3. Align dust extraction port (u) against the bracket
on the shoe as shown.
4. Align tab on the dust extraction port with the
threaded hole on the bracket.
5. Insert screw and tighten securely.
MAINTENANCE
Your D
WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing and the guard area
with dry air as often as dirt is seen
collecting in and around the air vents.
Wear approved eye protection and
approved dust mask when performing
this procedure.
LOWER GUARD
The lower guard should always rotate and close
freely from a fully open to fully closed position.
14
Always check for correct operation before cutting
by fully opening the guard and letting it close. If the
guard closes slowly or not completely it will need
cleaning or servicing. Do not use the saw until it
functions correctly. To clean the guard, use dry air
or a soft brush to remove all accumulated sawdust
or debris from the path of the guard and from
around the guard spring. Should this not correct the
problem, it will need to be serviced by an authorized
service center.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
Optional Accessories
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
accessories should be used with this
product.
DO NOT USE WATER FEED ATTACHMENTS WITH
THIS SAW.
VISUALLY EXAMINE CARBIDE BLADES BEFORE
USE. REPLACE IF DAMAGED.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
WALT, have
e
WALT, recommended
e
WALT product
e
Advertisement
Table of Contents
