Dogwidgets DW-5 User Manual

Dogwidgets DW-5 2 dog training shock collars user's manual

Preparation:

1) Check the 9-volt battery of the remote control and see if it's properly installed. The +/- side of the battery should touch
against the 2 springs of the remote control. Follow the diagram inside the battery compartment on where to put the +/- side
of the 9-volt battery.
2) Charge the collars for 8 hours straight for the first charge and 4 to 6 hours after. The red led light of the collar will flash,
meaning the collars are charging. Red led light of the collars will go solid after a full charge.
3) Install the rubber prongs if you have a small/medium size dog or the metal prongs if you have a medium/large dog.
4) Test the shock of the collars by using the wire shock tester. Wrap the wires around the 2 metal posts of the collar then
press the shock button. The bulb will light up if the collar is giving a shock.
5) Install the strap to the collar by inserting them through the 2 brackets on the collar. Adjust the length and snug fit the
collar to your dog's neck.
.