Advertisement
www.drivemedical.com
Rev.03.02.23.17
lifetime limited
warranty
Your Drive branded product is warrantied to be
free of defects in materials and workmanship for
the lifetime of the product for the original con-
sumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable
components,
such
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2015 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
bariatric
transfer bench
item #12025KD-1
#12025KD-2
as
rubber
EU Authorized Representative
Drive Medical LTD
Ainley's Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP
www.drivemedical.com
Advertisement
Table of Contents
Related Manuals for Medical Depot Drive 12025KD-1
Summary of Contents for Medical Depot Drive 12025KD-1
- Page 1 EU Authorized Representative Drive Medical LTD Ainley’s Industrial Estate Elland, West Yorkshire, United Kingdom HX5 9JP © 2015 Medical Depot, Inc. All rights reserved. Drive is a trademark of Medical Depot, Inc. www.drivemedical.com www.drivemedical.com Port Washington N.Y. 11050 USA Made in China...
- Page 2 5. To assemble backrest, insert pole into backrest 7. Turn transfer bench right-side-up. Attach armrest assembly instructions support and lock in place using attached locking collar. by depressing brass push pins and sliding into the arm Repeat for second pole (Figure 3). receptacle on the side of the bench. Make sure the 1. Remove contents from carton. arm arcs outward, not inward (Figure 5). 2. Lay transfer bench upside down on a flat surface. 3. Attach leg with the large suction cup by depressing the brass push pin and inserting into the receptacle. Repeat for second leg (Figure 1). Note: These legs are inserted into the same side that the arm support will be. figure 3 6. Insert backrest into base by sliding supports through both receptacles and locking in place using attached figure 5 locking collars, NOTE: Back support is reversible to accommodate left or Note: backrest must go through both sets of right tub entry. receptacles to become secure (Figure 4). 8. Place legs with suction cups into bath tub. figure 1 NOTE: Pull Tab on the suction cup to release from the tub. 4. Attach leg with small rubber tip by depressing brass Adjust legs to the need of the patient.
Need help?
Do you have a question about the Drive 12025KD-1 and is the answer not in the manual?
Questions and answers