SEWING MACHINE - Do not use the appliance if the cable or plug is damaged. SW8220 - If any of the appliance casings breaks, immediately disconnect the ap- pliance from the mains to prevent the possibility of an electric shock.
DESCRIPTION 4. Hang into the take-up lever from right to left When the take-up lever is in its highest position. A Tension disk B Upper thread spindle C Thread cap D Upper thread E Under threas winding shaft F Stop poling G Hand wheel H Reverse lever 5.
3. Pull out about 10 cm of thread from the bobbin and insert the bobbin - Note: The upper and bobbin thread must be correctly installed. Sew so it winds to the right. a test piece to make sure the machine is sewing correctly and then begin sewing your project.
- Be careful because the needle will move up and down. 2. While holding the used needle, use a bobbin/ coin to loosen the needle clamp screw counter clockwise to remove the needle. Remove 6. Stop the machine after you have wound the appropriate length of the needle and dispose of it appropriately.
- Increase the number of the upper thread tension dial. - Turn the upper thread tension dial down to increase the number until the stitches become normal and the upper thread tension is tight. The upper thread should appear straight Upper thread is too tight - Reduce the number on the upper thread tension dial.
Page 8
- CAUTION: make sure the foot pedal is unplugged from the machine when you’re not using it, so the sewing machine won’t accidentally start up. HOW TO USE THE SEWING MACHINE WITH THE FOOT PEDAL - Make sure power /speed switch in “pedal” position when you operate sewing machine with Foot pedal.
Page 9
WHEN CHANGING SEWINGDIRECTION WHEN CHANGING SEWINGDIRECTION - Hints: If the thread is caught and you cannot remove the fabric, rotate the hand wheel back and forth slightly to make it easier to remove the 1. OFF: Stop the sewing machine placing the sped knob to “Foot pedal 1.
5. Raise the presser foot lock lever to secure the presser foot to the presser holder. 6. Raise the presser foot lifter, pass the upper thread and the bobbin thread through the buttonhole presser foot so they come out from the side.
STORAGE AND DISPOSAL 5. Lower presser foot lifter and make sure the needle is in its high position. - Store this product in a dry and safe location, and no keep it in any of 6. Select Pattern selection dial to “ ”...
TROUBLESHOOTING: Trouble Causes Solution Lamp does not 1. No pwer supply. 1. Turn the power supply switch ON and supply power. illuminate 2. AC adaptor are not installed 2. Make sure the AC adaptar are oriented correctly and reinstall them correctly.
Need help?
Do you have a question about the SW8220 and is the answer not in the manual?
Questions and answers