AEG S72300DSW1 User Manual page 22

22 www.aeg.com
Problem
The appliance makes
noise during operation.
The appliance does not
operate.
The lamp does not come
on.
The compressor operates
continuously.
Water collects on the rear
plate of the fridge.
Water collects in the
fridge.
There is water on the
floor.
The temperature in the
appliance is too cold
The temperature in the
appliance is not sufficient-
ly cold.
Possible solution
Some sounds are normal when the appliance is
operating. Refer to the leaflet supplied with the
appliance.
Make sure that the appliance is activated.
Make sure that the mains plug is connected to the
mains socket.
Do a check and see if there is voltage. Connect a
different appliance to the same mains socket. To
repair a mains socket, contact a qualified electri-
cian.
Close and open the door to make sure that the
lamp is not in standby.
The lamp is defective. Replace the lamp.
Set the temperature knob at a lower position.
Make sure that the appliance door is closed.
Make sure not to open and close the appliance
door too frequently.
Make sure not to put hot food in the appliance.
Wait until it becomes cool.
Make sure that the room temperature is not too
warm.
It is normal that this occurs when the automatic de-
frosting operates.
Make sure that the drain hole is not clogged.
Make sure that food or packaging do not prevent
the water to collect in the water container.
The melting water outlet does not flow in the
evaporative tray above the compressor.
Attach the melting water outlet to the evaporative
tray.
Set the temperature knob to a lower position.
Set the temperature knob to a higher position.
Make sure that the appliance door is closed.
Make sure not to put hot food in the appliance.
Wait for the food to become cool.
Make sure that the appliance is not too full.