General safety precautions WARNING! When using electric tools, basic safety precautions should always be fol- lowed to reduce the risk of fire, electric shock and personal injury, including the following. Read all these instructions before operating this product and save these instructions. For safe operations: Keep work area clean.
When heat treating use clamps, vice or other ways of secure mounting of work piece. • Handholding work piece is not secure and may cause loss of balance, tool damage or body injury. Description 1. Nozzle 2. Temperature control 3. Handle technical specifications Model HAG-2000-1 Rated power 2000 W...
Rated voltage 220-240 V Rated frequency 50-60 Hz Air flow 13-19 m/s Air temperature 300/500 С Standard delivery includes set of nozzles. intenDeD use Removing paint On profiled surface, paint can be removed using an appropriate fitting spatula and brushed off with a soft wire brush. Cable shrinking Heat-shrinkable sleeve is installed on the insulation place and is heated by hot air flow.
3. Extension cord. When the work area is far away from the power source, use an extension cord of suf- ficient thickness and rated capacity. The extension cord should be kept as short as prac- ticable. 4. Temperature control Before adjusting air temperature make sure the power switch is in the “Off” position. To adjust press the switch and adjust air flow temperature by turning the temperature dial.