Table of Contents
Advertisement
STANDARD CONNECTIONS
MULTICHANNEL SOUND FOR HOME THEATRE
8
20
18
16
14
12
10
6
4
2
21
19
17
15
13
11
9
7
5
3
1
DIGITAL AUDIO
For multichannel sound, your player provides both digital and
analog audio outputs.
DIGITAL (MPEG 2 MULTICHANNEL OR DOLBY
DIGITAL™) MULTICHANNEL SOUND
1 For this, which provides the highest multichannel sound
quality, you need a digital multichannel A/V receiver.
2 Connect the digital audio output on the rear of the player to
a suitable input on the receiver using a digital audio cable
(available as option). In this case, do not use the player's
audio Left and Right outputs.
3 You will need to activate the digital output of the player
(See Settings p. 20).
4 The audio format of the digital output is dependent on the
audio format of the selected audio stream. Make sure that
the selected audio stream matches the capabilities of the
receiver connected to the digital output.
ANALOG (DOLBY PRO LOGIC™) MULTICHANNEL
SOUND
1 If your TV set has a Dolby Pro Logic™ decoder, simply hook
up the player to the TV using the A/V Euroconnector, or
Video (CVBS) and audio connections as on p. 9.
2 If not, make the A/V Euroconnector, or Video (CVBS) con-
nection to the TV p. 9, and connect the player's audio Left
and Right outputs to suitable inputs on a Dolby Pro Logic™
Audio/Video receiver, using the cable supplied.
3 For speaker connections, follow the instructions given in
the TV set or A/V receiver user manual.
NOTE
- You cannot use the RF Modulator option for home theatre.
- If the audio format of the digital output does not match the
capabilities of your receiver, the sound will be muted.
english
10
DIGITAL AUDIO
IN
RECEIVER
CABLE
DIGITAL AUDIO (STEREO) SOUND
CONNECTION
For this connection, which produces the highest possible
stereo sound quality, you need an audio amplifier with digital
input, and the digital output of the player must be activated
(see Settings p. 20). Connect the player's digital audio output
to the corresponding input on the amplifier. In this case, do
not use the player's audio Left and Right outputs.
NTSC/PAL SETTING
Use the NTSC/PAL switch on the rear of the player to set the
Video CD and player menu according to the standard used by
your TV-set.
NOTE
- The video output standard for video CD and DVD-Video discs
most corresponds to the disc being played.
CONNECTING THE POWER SUPPLY
1 Plug the female end of the power cord supplied into the
Power connector on the rear of the player.
2 Plug the male end of the cord into an AC outlet.
NOTE
- The player automatically adjust to the local AC voltage.
- When the player is in the "OFF" position, it still consumes
some power. If you wish to disconnect your player com-
pletely from the power supply, withdraw the plug from the
AC Outlet.
CAUTION
Only qualified service personnel should remove the
cover or attempt to service this device.
Advertisement
Table of Contents
