Summary of Contents for Butts of Bawtry BAT0020
- Page 1 1/4" AIR ANGLE DIE GRINDER BAT0020 ORIGINAL INSTRUCTIONS SAVE THESE INSTRUCTIONS AND PRECAUTIONS. READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.
-
Page 2: Safety Instructions
1.SAFETY INSTRUCTIONS WARNING– When using tools, basic precautions should always be followed, including the following: 2.General To reduce the risks of electric shock, fire, and injury to persons, read all the instructions before using the tool. 3.Work area a. Keep the work area clean and well lighted. Cluttered benches and dark areas increase the risks of electric shock, fire, and injury to persons. - Page 3 your finger on the switch or connect the tool to the air supply with the switch on. d.Remove adjusting keys and wrenches before connecting an air hose to the Air Angle Die Grinder on. A wrench or a key that is left attached to a rotating part of the tool increases the risk of personal injury.
- Page 4 repaired. d.Disconnect the tool from the air source before making any adjust- ments, changing accessories, or storing the tool. Such preventive safety measures reduce the risk of starting the Air Angle Die Grinder unintentionally. Turn off and detach the air supply, safely discharge any residual air pressure, and release the throttle and/or turn the switch to its off position before leaving the work area.
- Page 5 a.Never connect to an air source that is capable of exceeding 200 psi. Over pressurizing the tool may cause bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool.
- Page 6 the tool do the work. g.To reduce vibration, maintain tool as explained in this manual. If abnormal vibration occurs, stop immediately. 9.Functional Description Specifications Max. speed: 20000/min Max air pressure: 6.2bar Avg. air consumption: 3cfm Air inlet :1/4" Max. chuck size: 1/4" Hose size: 3/8”...
- Page 7 1. Incorporate an in-line oiler, shut-off valve, regulator with pressure gauge, and filter for best service, as shown in the diagram above. An in-line shut off valve is an important safety device because it controls the air supply even if the air hose is ruptured. Note: If an automatic oiler system is not used, add a few drops of Pneumatic Tool Oil to the airline connection before operation.
- Page 8 Note: Air flow, and therefore Air Angle Die Grinder performance, can be hindered by undersized air supply components. a. The air hose must be long enough to reach the work area with enough extra length to allow free movement while working. b.
- Page 9 4. Insert 1/4” diameter shank of a Grinding Accessory (not included) fully into Collet Nut. Then, firmly re-tighten Collet Nut to lock both the Collet and Grinding Accessory in place. 5. Connect air supply hose to Air Inlet. Turn on air compressor and set its regulator to the maximum 90 PSI for Die Grinder.