D-Link WUA-1340 Manual page 12

Using the Configuration Utility (continued)
Ad-Hoc Channel:
All devices in the Ad-Hoc
network must be set to the
same channel.
Profile IP Settings:
You can Enable
Disable the IP Settings
portion of your profile here.
If you select Disable you
will need to configure the IP
address information each
time you connect to a
network. If you select
Enable you will maintain
the same IP address
information each time you
connect to a network.
Power Mode:
Disable -This default setting consumes the most power.
Enable - This setting consumes the least power.
Launch Utility on Startup:
Select Enable or Disable.
Data Packet Parameter:
Select the parameters here.
Fragmentation Threshold:
This value should remain at its default setting of 2432. If you experience a
high packet error rate, you may slightly increase your Fragmentation
Threshold within the value range of 256 to 2432. Setting the Fragmentation
Threshold too low may result in poor performance.
RTS Threshold:
This value should remain at its default setting of 2432. If inconsistent data
flow is a problem, only a minor modification should be made.
Click Apply if you have made any changes.
Advanced
or
9