Fig. 100: Fitting The Upper Fastening Strips; Fig. 101: Fitting The Bottom Fastening Strip; Table 61: Tightening Torque (51007) - ABB HT607792 Operation Manual

Operation Manual / A150-M58/68
12 Dismantling and fitting, special tools for fastening strips / 12.1 Ap-
plication, special tools
5. Loosen the nuts (51007) from the remaining fastening strips and remove the lugs (51002)
with washers (51003).
Fitting the fastening strips
Fig. 100: Fitting the upper fastening strips
Product
A150-M58/68
Table 61: Tightening torque (51007)
1. Fit nuts (51007) of the (upper) fastening strips (51002) shown in the picture and tighten
with the torque spanner (02) without a spanner holder. Observe the tightening torque.
Fig. 101: Fitting the bottom fastening strip
2. Position the collection tray (01) to catch any fixing elements if they fall.
3. Tighten the two nuts on one side using the spanner holder (90165).
4. Tighten the two nuts on the other side using the spanner holder (90166).
© Copyright 2021 ABB. All rights reserved.
Size
M16
HZTL4041_EN
Tightening torque [Nm]
175
Rev.E January 2021