Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Bloomfield 9460KFT
Summary of Contents for Bloomfield 9460KFT
- Page 1 OWNERS MANUAL SOLUBLE COFFEE DISPENSERS MODEL: 9460KFT Includes: Installation Operation Use & Care Servicing Instructions Model 9460 Dispenser PRINTED IN UNITED STATES OF AMERICA 76832 Rev. E ECN-12743 M725 0825 cps...
-
Page 2: Warranty Statement
The prices charged by Bloomfield Industries for its products installation or eighteen (18) months from the date of shipment are based upon the limitations in this warranty. -
Page 3: Table Of Contents
208/240 VAC 4657 W/ 22.4 A @ 208V 2-Wire (L1 + L2) Dispenser Single Phase 6200 W 25.8 A @ 240V Plus GND (NOT SUPPLIED) APPLICABILITY This manual applies to the following Bloomfield Industries products: Model 9460KFT Soluble Coffee Dispenser... -
Page 4: Features & Operating Controls
FEATURES AND OPERATING CONTROLS Fig. 1 Features & Operating Controls ITEM DESCRIPTION ITEM DESCRIPTION DOOR ASSEMBLY CANISTER SHELF ILLUMINATED TRANSLIGHT WATER DISPENSE ADAPTER (3 ea.) "COFFEE" DISPENSE SWITCH DISPENSING NOZZLE (3 ea.) "DECAF" DISPENSE SWITCH VACUUM ADAPTER (2 ea.) "HOT WATER" DISPENSE SWITCH MIXING CHAMBER (2 ea.) HEATER ON/OFF SWITCH POWER DISPENSING ELBOW (2 ea.) -
Page 5: Precautions & General Information
PRECAUTIONS AND GENERAL INFORMATION WARNING: Electric Shock Hazard All servicing requiring access to non-insulated components must be performed by qualified service personnel. Do not open any access panels which require the use of tools. Failure to heed this warning can result in electrical shock. WARNING: Injury Hazard All installation procedures must be performed by qualified personnel with full knowledge of all applicable electrical and plumbing codes. -
Page 6: Installation Instructions
12 feet and 3/8" for Model 9460KFT requires a 1/4" female flare fitting to connect to more than 12 feet from a 1/2" the water inlet fitting on the bottom of the unit. - Page 7 Fig. 2b Water Supply Installation - Hot Water The DRIP TRAY pan is equipped with a drain outlet. Bloomfield recommends that this drain outlet be connected to 1/2" I.D. flexible tubing and routed to a building drain. If a drain line is not used, the supplied plug on the pan drain fitting must remain in place.
- Page 8 DO NOT dispenser is connected to the water supply. assume a plumbing line will Model 9460KFT requires a dedicated 208 volt or 240 volt single provide such a ground. phase 30 amp circuit. For power supply connections use 10AWG Electrical shock will cause death copper wire suitable for at least 90ºC...
-
Page 9: Operation - Dispensing Coffee
OPERATION - DISPENSING COFFEE PREPARATION CAUTION Burn Hazard Press the SOLENOID ON/OFF SWITCH to ON. Dispense nozzles may be Press the SERVE/SANITIZE switch to SERVE. HOT to the touch, and can cause serious burns. Fill PRODUCT CANISTERS with the appropriate product. Left (large canister) - Regular Coffee Right (small canister) - Decaf Coffee CAUTION... -
Page 10: Cleaning Instructions
CLEANING INSTRUCTIONS CAUTION PROCEDURE: Clean Coffee Dispenser BURN HAZARD PRECAUTIONS: None Dispensing and serving FREQUENCY: Daily temperatures of coffee are TOOLS: None Required extremely hot. Hot coffee will cause serious skin burns. 1. Press the SERVE/SANITIZE SWITCH to SANITIZE. 2. Place an empty 1/2 gallon container under the "COFFEE" CAUTION dispense nozzle. - Page 11 CLEANING INSTRUCTIONS (continued) CAUTION PROCEDURE: Clean Coffee Dispenser BURN HAZARD PRECAUTIONS: Disconnect dispenser from electric power. Allow dispenser to cool. Dispensing and serving FREQUENCY: Weekly temperatures of coffee are extremely hot. TOOLS: Mild Detergent, Clean Soft Cloth or Sponge Hot coffee will cause Soft Bristle Brush, Bottle Brush serious skin burns.
- Page 12 3. Disassemble AUGER from canister. chlorinated cleansers to clean NOTE: While the AGITATOR wheel and spring assembly the dispenser or components. may be removed from the canister, Bloomfield recommends that it be removed only if necessary for repair. IMPORTANT: Left and right canisters use 4.
-
Page 13: Troubleshooting Suggestions
TROUBLESHOOTING SUGGESTIONS SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY No power to brewer Power switch off Turn power switch on Circuit breaker off or tripped Reset circuit breaker Hi-limit tripped Allow to cool, reset hi-limit Water not heating Tank heat switch off Turn tank heat switch on Heating thermostat set too low Set to desired temperature... -
Page 14: Servicing Instructions
SERVICING INSTRUCTIONS PROCEDURE: Adjust Water Volume PRECAUTIONS: Disconnect brewer from electric power. Allow brewer to cool. FREQUENCY: As required (water volume is too high or low, or as required for coffee taste) TOOLS: Flat Blade Screwdriver #2 Phillips Screwdriver 1. Carefully remove product canisters. Place an appropriate container in position under the dispense nozzles. - Page 15 SERVICING INSTRUCTIONS (continued) NOTE; Adjust water volume PROCEDURE: Adjust Mixture (see page 12) before adjusting mixture. PRECAUTIONS: None: FREQUENCY: Initial Setup, or as required TOOLS: Water volume calibrated in fluid ounces Recommended ratio is: Scale calibrated in grams 0.25 grams of powder Stopwatch Container to collect dispensed powder fluid ounce of water.
- Page 16 SERVICING INSTRUCTIONS (continued) PROCEDURE: Program Portion Control CAUTION - ELECTRIC SHOCK PRECAUTIONS: Possible exposed electrical circuits HAZARD Panels removed for this FREQUENCY: When needed procedure may expose live electrical circuits. Use due TOOLS: #2 Phillips Screwdriver caution around wiring and Small pointed stylus (or ballpoint pen) connectors.
-
Page 17: Deliming Instructions
8. Reconnect dispenser to electrical supply and reconnect water delimed. Should deliming supply. hoses become necessary, Bloomfield recommends 9. Place the SERVE/SANITIZE SWITCH in SANITIZE position. replacing the hoses. Run at least 2 gallons through each dispense nozzle and discard all water generated. -
Page 18: Exploded View & Parts List
EXPLODED VIEW & PARTS LIST (continued) 9460 SOLUBLE COFFEE DISPENSER... - Page 19 EXPLODED VIEW & PARTS LIST (continued) ITEM PART NO. DESCRIPTION ITEM PART NO. DESCRIPTION ILLUMINATED DOOR ASSEMBLY 86310 CUP GRID SEE EXPLODED VIEW, PAGE 15 86902 THERMOSTAT 174° HOT WATER TANK ASSEMBLY SEE 85834 BLOWER EXPLODED VIEW, PAGE 18 DISPENSER SWITCH ASSEMBLY 86281 GRID, DRAIN PAN SEE EXPLODED VIEW, PAGE 15...
- Page 20 EXPLODED VIEW & PARTS LIST TANK ASSEMBLY...
- Page 21 SWITCH ASSEMBLY ITEM PART NO. DESCRIPTION 85504 HANDLE, SWITCH "COFFEE" 85513 HANDLE, SWITCH "DECAF" 85514 HANDLE, SWITCH "HOT WATER" 85502 BONNET, SWITCH ASSY 85507 PIN, HANDLE 87050 SPRING, LQ COFFEE SWITCH 85501 WASHER, SHAFT STOP 85503 SHAFT, LQ COFFEE SWITCH 85500 BRACKET, SWITCH MOUNTING 50198...
-
Page 22: Wiring Diagram
WIRING DIAGRAM - MODEL 9460KFT... - Page 23 Bloomfield Industries, Inc. Division of Carrier Commercial Refrigeration In US and Canada Telephone: 775-698-5700 Fax: 888-492-2783 Fax: 800-356-5142 ( for orders only website: www.wellsbloomfield.com PRINTED IN UNITED STATES OF AMERICA...
Need help?
Do you have a question about the 9460KFT and is the answer not in the manual?
Questions and answers