Radio Operation - Crosley McQueen CR7011-GY Instruction Manual

English

Radio Operation

1. Press the Power Button to turn on the power.
2. Set the Function Switch to the RADIO position, press the AM/FM Button to
set the desired radio band.
3. Rotate the Tuning Knob for the desired radio station.
Note:
 The unit is equipped with a FM wire antenna. To FM improve reception, move the
wire around until the reception is clear without interferences. Do not connect the wire
to any additional antenna.
 The AM antenna is built inside the unit. If AM reception is poor, try to rotate the unit
for better reception.
CD Playback Operation
1. Press the Power Button to turn on the power.
2. Set the Function Switch to the CD position.
3. Press the Open/Close button to open the CD tray and put the CD in the tray
with the labeled side facing up.
4. Press the Open/Close button again to close the tray. The LED display will
show "--" for a few seconds, then the total number of tracks on the CD. If it is
a blank CD or an unrecognizable CD, it will show "00".
Note: MP3 or similar types of digital audio files cannot be read by the CD player.
5. Press the Play/Pause button to start the playback. The Play Indicator will light
up.
6. During the playback, press the Play/Pause button to pause and the Play
Indicator will starting flashing. Press it again to resume playback.
7. To skip to the next or previous track, press the Forward Skip or Backward
Skip button correspondingly.
8. To search fast forward or backward, press and hold the Forward Skip or
Backward Skip button correspondingly until you reach the desired time.
Release the button and the playback will resume.
9. To repeat a specific track, press Repeat button once while that track is
playing and the Repeat Indicator will start flashing. To repeat all the tracks,
press the Repeat button twice and the Repeat Indicator will remain on. To
cancel repeat function, press the Repeat button until the Repeat Indicator is
off.
10. Press the Stop button if you want to completely stop playback.
Programmed Playback
1. Before starting the playback, press the Program button once to enter
program mode. The Program Indicator will start flashing. The LED display
will flash "01" as the track sequence which is to be edited.
8