Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Mezger AC-1
- Page 1 Bluetooth TWS Earbuds AC-1 User Guide...
- Page 2 INCLUDED A) Left ear bud B) Right ear bud C) Charging case D) XS/S/M/L silicone tips E) S/M/L memory foam tips F) Charging cable...
- Page 4 CHARGING To charge the earphones, place them in the charging case, wait for white LED to turn RED and close the lid. Open the case to check if the red LED has turned off. If the LED is off, earphones are fully charged. Charging...
- Page 5 time is approximately 1.5 hours for 6 hours of playtime. A fully charged case provides 5 extra earphone charges when on-the-go. The number of lights indicates the charging case battery status when the earphones are placed in the case. 3 lights = 67-100% charged, 2 lights = 34-66% charged, 1 light = 1-33% charged, 0 lights = 0% charged.
- Page 7 Activate Bluetooth functionality on the input device, select Mezger AC-1, once connected the LEDs will flash white twice. The product is ready for use. Mezger AC-1 remembers previously connected devices.
- Page 8 FITTING Mezger AC-1 contains silicone tips and memory foam tips. Mezger AC-1 is fitted with medium silicone tips out of the box. When using the memory foam tips, squeeze down the foam tip and roll the tip into a thin, round cylinder.
- Page 10 5 seconds to reject. During a call, double tap either one of the earphones to terminate the call or triple tap to transfer audio from Mezger AC-1 to the connected device.
- Page 11 Single tap: Play / pause / accept call Double tap: Skip to next song / end call Single tap: Play / pause / accept call Double tap: Skip to previous song / end call...
-
Page 12: Care And Maintenance
Keep away from water lorem ipsum dolor sit amet consectatur. Keep away from magnets - as these can damage the drivers lorem ipsum dolor sit amet consectatur. Should you wish to have your headphones serviced at any point, contact: servicing@mezger-audio.com... -
Page 13: Warranty And Servicing
This product comes with a 2 year warranty. In the event that you encounter a fault within 2 years of purchasing contact: warranty@mezger-audio.com If you experience an issue outwith the period of warranty, or want to upgrade your headphones, you can send them to us. We will review the headphones and repair or upgrade at a fixed cost of £45 plus shipping, or salvage... - Page 14 Directive 2014/53/EU and all other applicable EU directive requirements. The complete declaration of conformity can be found at: www.mezger-audio.com/compliance This product conforms to all applicable Electromagnetic Compatibility Regulations 2022 and all other applicable UK regulations.
- Page 15 PRECAUTIONS Do NOT use the earphones at a high volume for any extended period. To avoid hearing damage, use your earphones at a comfortable, moderate volume level. Turn the volume down on your device before placing the earphones in your ears, then turn the volume up gradually until you reach a comfortable listening level.
- Page 16 This could result in the potential of missed communications while piloting an aircraft. Extremely loud ambient noise levels common to many propeller-driven aircraft may impair your ability to receive incoming audio communications, particularly during takeoff and climb out.– Mezger AC-1 earphones are not...
- Page 17 engineered for noise conditions, altitude, temperature or other environmental conditions common in non-commercial aircraft, resulting in possible interference to critical communications. Do NOT place naked flame sources, such as lighted candles, on or near the product. Do NOT make unauthorized alterations to the product;...
- Page 18 This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement in portable exposure condition without restriction. mezger-audio.com...
- Page 19 ISED statement English: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Need help?
Do you have a question about the AC-1 and is the answer not in the manual?
Questions and answers