Advertisement
Introduction
Thanks for choosing the Vision's repeater of the home automation device. This
module is a Z-Wave™ enabled device (interoperable, two-way RF mesh
networking technology) and is fully compatible with any Z-Wave™ enabled
network. Every main powered Z-Wave enabled device acts as a signal repeater
and multiple devices result in more possible transmission routes which helps
eliminate "RF dead-sports"
Z-Wave™ enabled devices displaying the Z-Wave™ logo can also be used with it
regardless of the manufacturer, and ours can also be used in other
manufacturer's Z-Wave™ enabled networks. This device take existing Z-WAVE
signal, repeat and send it to a longer range where it is too far away for the
controller (supporting FLiRS devices).
Product Description and Specification
*** For indoor use only ***
(2)
(1)
Release the bracket:
(1) Press
(2) Slide down to release the bracket
Specification:
Protocol: Z-Wave™ (ZM4101)
Frequency Range:
865.22MHz (ZR1202IN)
868.42MHz (ZR1202EU)
869.00MHz (ZR1202RU)
908.42MHz (ZR1202US)
916.00MHz (ZR1202IS)
920-928MHz(ZR1202JP)
921.42MHz (ZR1202BR)
Operating Range: Up to 200 meters
Operating Temp.: -15°C~ 60°C (5°F ~140°F)
Operating Voltage: 5V/DC
Current Consumption: 300mA (±50mA)
Z-Wave™ Command Class:
COMMAND_CLASS_BASIC
COMMAND_CLASS_MANUFACTURER_SPECIFIC
COMMAND_CLASS_POWERLEVEL
COMMAND_CLASS_VERSION
Micro USB Power Input
Program Switch
Package Content:
1pc
ZR1202 Repeater module
1pc
ZR1202 Repeater Bracket
1pc
Adapter (Optional)
1pc
Installation & Operation Manual
-1 -
※Note: Suitable adapter specification:
-Micro USB Power Input
-Operating Voltage: 5V/DC
-Current Consumption: 500m
Installation
Notice: If you are installing the entire Z-Wave™ system for the first time, please
refer to the installation guide of Z-Wave™ Interface Controller before installing ZR
1202 Repeater Module.
1. Fix the repeater under the vertical way as high as possible then insert the
suitable Micro USB Power Adaptor to the ZR1202 then it will go to the
Learning Mode automatically. (The LED will start flash which means the
repeater has not been "Include" yet.)
2. For "Inclusion" in (adding to) a network: Put the Z-Wave™ Interface
Controller into" inclusion" mode and following its instruction to add the
ZR1202 to your controller. To get in the "inclusion" mode, the distance
between module and controller is suggested to be in one meter. Press the
program switch on the ZR1202 once. The LED should stop flashing, if not,
please try again.
For "Exclusion" from (removing from) a network: Put the Z-Wave™ Interface
Controller into "exclusion" mode, and following its instruction to delete the
ZR1202 from your controller. Press the program switch on the ZR1202 once
to be excluded.
Note: LED setting light will flash continuously in Exclusion condition.
3. Use "Power Level Set" command for setting the strength of RF during one
period.
4. Use "Power Level Test Node Set" command to test the direct signal for fixed
node.
5. Support Repeaters for routing (FLiRS included)
6. Support Explorer Frame function
7. Press Program Switch for 5 seconds, the ZR1202 will reset back to factory
default.
★ The ZR1202 operating range will be up to 200 meters under
the correct installation!!
-2 -
Advertisement
