Elenco Electronics AM/FM-108CK Assembly And Instruction Manual page 27

STATIC MEASUREMENTS
Q7 BIAS
Connect your VOM to the circuit as shown in Figure 20.
Connect a clip lead from TP6 to the collector of Q7.
This short prevents Q7 from oscillating. Set the VOM to
read 2 volts DC and turn the power ON. The DC
voltage at TP7 should be about 1.6 volts. If the voltage
If you do not have an oscilloscope, skip to the AM Final Alignments.
DYNAMIC MEASUREMENTS
AM OSCILLATOR CIRCUIT
Connect your test equipment to the circuit as shown in Figure 21.
Set the scope to read 1 volt per division and turn the
power ON. The scope should display a low voltage
sinewave. The frequency of the sinewave should
Short TP6 to the collector of Q7 as shown below.
Figure 20
Figure 21
in your circuit differs by more than .5 volts, leave the
power ON and check the battery voltage. If the battery
voltage is greater than 8.5 volts, check components
R31, R32, R33 and Q7. Turn the power OFF.
change when the tuning gang is turned. If your circuit
fails this test, check components Q7, gang capacitor,
C28, C29, C30, C31, L4 and L5. Turn the power OFF.
-26-
V
COM V
TP15
Oscilloscope
TP15