A SYSTEMS SR707 User Manual

A SYSTEMS SR707 User Manual

Contractor power amplifier
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

User's Manual
Manual del Usuario
Contractor Power Amplifier
Amplificador de Potencia Para Contratistas
SR703
SR707

Advertisement

Table of Contents
loading

Summary of Contents for A SYSTEMS SR707

  • Page 1 User’s Manual Manual del Usuario Contractor Power Amplifier Amplificador de Potencia Para Contratistas SR703 SR707...
  • Page 2: Table Of Contents

    SR703 | SR707 CONTRACTOR AMPLIFIER CONTENTS INTRODUCTION �������������������������������������������������������������������������������������������������������������������������� 4 FEATURES ����������������������������������������������������������������������������������������������������������������������������������� 4 PRECAUTIONS ���������������������������������������������������������������������������������������������������������������������������� 4 ABOUT THIS MANUAL ���������������������������������������������������������������������������������������������������������������� 4 FRONT PANEL ����������������������������������������������������������������������������������������������������������������������������� 4 REAR PANEL ������������������������������������������������������������������������������������������������������������������������������� 5 INPUTS - BARRIER STRIPS ������������������������������������������������������������������������������������������������������� 6 OUTPUTS - BARRIER STRIPS ��������������������������������������������������������������������������������������������������� 6 SPECIFICATIONS ������������������������������������������������������������������������������������������������������������������������...
  • Page 3 SR703 | SR707 CONTRACTOR AMPLIFIER IMPORTANT SAFETY INSTRUCTIONS The apparatus shall not be exposed to dripping or splashing and that no objects with liquids, such as vases, shall be placed on the apparatus. The MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable.
  • Page 4: Introduction

    3. Signal “Status” LED Indicator PRECAUTIONS Each channel of the SR703 and SR707 features a signal LED to show that there is an audio signal at the input to the channel� The threshold for the indicator is -26dB, which 1.
  • Page 5: Rear Panel

    SR703 | SR707 CONTRACTOR AMPLIFIER REAR PANEL 9. Stereo / Parallel / Bridge Switch In Stereo operation, two separate signals are treated 5. Gain Controls separately by channels 1 and 2 of the amplifiers. These two knobs are the level controls for channels one In Parallel operation, one signal is treated by bother and two respectively�...
  • Page 6: Inputs - Barrier Strips

    SR703 | SR707 CONTRACTOR AMPLIFIER INPUTS - BARRIER STRIPS Direct Low Impedance Balanced connection - Attach as shown� Connect the (+) Output connection, bridge mono mode wire, (-) wire and ground wire to terminal pins as marked� Positive Terminal Ground...
  • Page 7 Bridge Mono Configuration for Audio Transformer Outputs SR703 and SR707 are among the few amplifiers available that can do that� However, since most of the audio power 1. For driving 140V or 200V distributed lines, the amplifier is drawn by the direct-connected speaker, you must must be set to bridge mono mode�...
  • Page 8: Specifications

    SR703 | SR707 CONTRACTOR AMPLIFIER SPECIFICATIONS SR703 SR707 Direct Power Out 8 ohm 120 Watts x 2 240 Watts x 2 4 ohm 200 Watts x 2 400 Watts x 2 2 ohm,1kHz,1%THD 300 Watts x 2 550 Watts x 2...
  • Page 9 SR703 | SR707 AMPLIFICADOR DE POTENCIA PARA CONTRATISTAS Español...
  • Page 10: Introducción

    √ Protección de encendido (Power-up muting) 3. Indicador LED de Estatus de Señal Cada canal de los SR703 y SR707 tienen un LED de señal para mostrar si se tiene señal de audio a la entrada PRECAUCIONES del canal�...
  • Page 11: Panel Posterior

    SR703 | SR707 AMPLIFICADOR DE POTENCIA PARA CONTRATISTAS PANEL TRASERO 9. Selector Estéreo/Paralelo/Bridge En operación estéreo, dos señales separadas serán 5. Controles de Aumento de la Señal (GAIN) transmitidas por los canales 1 y 2 de los amplificadores. Estas dos perillas controlan el nivel para los canales uno En operación en Paralelo, una señal es tratada por...
  • Page 12: Conexiones De Entrada

    SR703 | SR707 AMPLIFICADOR DE POTENCIA PARA CONTRATISTAS ENTRADA - REGLETAS DE Baja impedancia directa CONEXIÓN Conexión de salida, modalidad bridge mono Conexión balanceada - Conecte el cable (+) y el cable de conexión a tierra (ground) a los pines de los terminales como se muestra adjunto�...
  • Page 13 Si sus aplicaciones necesitan la conexión de altavoces de 8 ohm y una línea distribuida al mismo canal; los SR703 y SR707 están de entre los muy pocos amplificadores que pueden hacer eso� Sin embargo, debido a que mucha de la potencia del audio se toma por la conexión directa del altavoz, deberá...
  • Page 14: Especificaciones

    SR703 | SR707 AMPLIFICADOR DE POTENCIA PARA CONTRATISTAS ESPECIFICACIONES SR703 SR707 Salida de Potencia Directa 8 ohms 120 Watts x 2 240 Watts x 2 4 ohms 200 Watts x 2 400 Watts x 2 2 ohms,1kHz,1%THD 300 Watts x 2...
  • Page 15: Appendix

    SR703 | SR707 CONTRACTOR AMPLIFIER DIMENSIONS DIMENSIONES 480 / 19 Measurements are shown in mm / inches Todas las medidas están mostradas en mm / pulgadas Appendix...
  • Page 16 www�asystems-sys�com...

This manual is also suitable for:

Sr703

Table of Contents