Table of Contents
Advertisement
Additional Information
Last Condition Memory
VCD1.1
DVD
CD
This player memorizes the last condition for the last disc
you have watched. Settings remain in memory even if
you remove the disc from the player or switch off the
player. If you load a disc that has its settings memo-
rized, the latest stop position is automatically recalled.
Notes
– Settings are stored in memory for use any time.
– This player does not memorize settings of a disc if
you switch off the player before commencing to play
it.
Screen Saver
The screen saver picture appears when you leave the
DVD Player in stop mode for about five minutes.
After the Screen Saver has been engaged for about five
minutes, the DVD Player will automatically turn itself off.
Video Mode Setting
With certain discs, the playback picture may be flick-
ering or Dot Crawl is shown on straight lines. That
means Vertical interpolation or De-interlace is not
perfectly matched with the disc. In this case, the
picture quality may be improved by changing the
video mode.
To change the video mode, press and hold DISPLAY
about 3 seconds during disc playback. The new video
mode number selected is displayed on the TV screen.
Check whether the video quality has improved. If not,
repeat the above procedure until picture quality is
improved.
Video mode change sequence:
MODE1 → MODE2 → MODE3 → MODE4 →
MODE5 → MODE1
If you turn off the power, the video mode will be back
to initial state (MODE1).
20
DVD
VCD2.0
VCD1.1
Controlling the TV
Your remote control is capable of operating your DVD
player as well as limited functions of LG TV.
Follow the instructions below to operate for your LG TV.
Before using the remote control, press the DVD or
1 1
TV button to select the device to be operated.
To switch the remote control mode (to operate a dif-
ferent device), be sure to press the DVD or TV but-
ton first.
The POWER, CH(
E E
/
D D
), VOL (1 1 / 2), MUTE and
2 2
TV AV buttons on remote control are used to oper-
ate the LG TV.
Setting Remote Control Codes for LG TV
This remote control supports two remote control
codes for LG TV: Code 1 and Code 2.
Code 1 is for LG TV with NTSC or multi system.
Code 2 is for LG TV with PAL system.
When the unit is shipped from the factory, the remote
control is set to Code 1.
To set the remote control to Code 2, hold down both
the TV button and "2" number button on the remote
control. (If the batteries in the remote control are
replaced while the remote control is set to Code 2,
the setting will revert Code 1.)
To set the remote control back to Code 1, hold down
both the TV button and "1" number button on the
remote control.
Note
If the remote control does not operate your particular
TV, try one of the other code or use the remote control
originally supplied with the LG TV.
Due to the variety of codes used by manufacturer, OUR
COMPANY cannot guarantee that the remote control
will operate every model of the LG TV.
Advertisement
Table of Contents
