Advertisement
Quick Links
CONVENTIONAL AIR CAP AND FLUID NOZZLE CHART
MODEL
Press /
AIR CAPS
NO.
Siphon
23-2010*
A300C
23-2013*
23-2014*
23-2016*
Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4)
*Gun inlet pressures may vary as required by application
Coating Atomization Technologies 337 South Arthur Avenue, Louisville CO 80027 Phone: 888.820.4498, Fax: 303.438.5708
*SUGGESTED
GUN INLET
CONTROL
PRESS.
ORIFICE
p/s
45-55
p/s
45-55
p/s
45-55
p/s
45-55
A A A A A ut
ut
ut oC
ut
ut
FAN
AIR CAP
SCFM
RING
9-10.7
None
23-0201
9-10.7
9-10.7
9-10.7
www.spraycat.com
oC
oC A A A A A T 300C
oC
T 300C
T 300C
T 300C
oC
T 300C
AUTOMATIC SPRAY GUN
PRODUCT INFORMATION
AVAILABLE FLUID
NOZZLES
33-0608 0.8mm (.022")
33-0610 1.0mm (.040")
33-0613 1.3mm (.052")
33-0614 1.4mm (.055")
33-0616 1.6mm (.063")
NEEDLES /
marking on needle
40-A308 (308)
40-A310 (310)
40-A313 (313)
40-A314 (314)
40-A315 (315)
Advertisement
Related Manuals for C.A. Technologies AutoCAT 300C
Summary of Contents for C.A. Technologies AutoCAT 300C
- Page 1 A A A A A ut ut oC oC A A A A A T 300C T 300C T 300C T 300C T 300C AUTOMATIC SPRAY GUN PRODUCT INFORMATION CONVENTIONAL AIR CAP AND FLUID NOZZLE CHART *SUGGESTED MODEL Press / AIR CAP AVAILABLE FLUID NEEDLES /...
- Page 2 A300C A300C A300C A300C A300C Operation and Maintenance Instructions for Spray Guns Gun Mounting A 1/2” dia. x 5” lg. rod is provided for mounting. The gun can be mounted from the left or right side or from the bottom. Thread the mounting rod (9) into one of the three holes that best suit the mounting location for the application.
- Page 3 ITEM NO. PART NO. DESCRIPTION ITEM NO. PART NO. DESCRIPTION See Air Cap Chart Air Cap Ring** 98-8006 O-Ring (Teflon)* See Air Cap Chart Air Cap** 98-7006 O-Ring (Viton) 2 Required* See Air Cap Chart Fluid Tip** 60-603 Air Control Spool 33-2201 Fluid Nozzle Body 98-7014...
- Page 4 FLUID NOZZLE / AIR CAP SELECTION CHARTS AUTOCAT Series 300C - Pressure / Siphon Feed Guns A300C CONVENTIONAL AUTOMATIC SPRAY GUN FLUID ORIFICE x MAXIMUM MATERIAL TYPE PRESS. / SIPHON AIR CAP PATTERN WIDTH Very Thin 0.8 mm x 2010 less than 16 sec.