Water Drainage - AEG LAVAMAT 12710 Instruction Booklet

Installation
The inlet hose must not be lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase a new, longer hose spe-
cially designed for this type of use.

Water drainage

The end of the drain hose can be positioned in three ways:
Hooked over the edge of a sink using the plastic hose guide sup-
plied with the machine. In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap
with a piece of string or attaching it to the
wall.
In a sink drain pipe branch. This branch
must be above the trap so that the bend is
at least 60 cm above the ground.
Directly into a drain pipe at a height of
not less than 60 cm and not more than
90 cm.
The end of the drain hose must always be ventilated, i.e. the inside
diameter of the drain pipe must be larger than the outside diameter of
the drain hose.
The drain hose
must
kinked. Run it
along the floor;
only the part near
the
point must be
raised.
48
not be
drainage