Errors; What Should I Do, If; Error Table - Pelgrim GVW446ONY Instructions For Use Manual

ERRORS

What should I do, if...

Error table

Problem
The dishwasher is not working.
The drainage pump does not
shut off.
Noise.
Contamination of the tub.
If the appliance is not functioning well, this does not always mean that
it is faulty. Try to resolve the fault yourself first. If the recommendations
below does not solve your problem, telephone our service department.
Note
Disconnect the appliance from the power supply before beginning
repairs. It is preferable if you remove the plug from the socket.
Potential causes
Fuse is faulty or the earthing switch has been
activated.
The power supply is not switched on
The water pressure is too low.
The water is running over.
Some noises are normal.
Cutlery is rattling in cutlery basket or
something small has fallen out of the basket.
The motor makes an unusual noise.
Poor quality detergent.
Blocked filters
Rinse agent has been spilled.
Solution
Replace the fuse or reset the isolating switch.
Remove other appliances that are connected to
the same group.
Make sure that the dishwasher is switched on
and the door closed.
Make sure that the plug is correctly inserted into
the socket.
Check whether the dishwasher is correctly
connected to the water mains and that the tap
is open.
The system is designed so that it can
automatically detect overflowing water. In that
instance, the appliance shuts off the circulation
pump and switches on the drainage pump.
Noise of rotating pump/washing noises; the
detergent compartment opening.
Ensure that everything is loaded securely in the
dishwasher.
The pump is blocked. Contact an installer.
Only use detergent suitable for dishwashers to
prevent contamination.
Open the door and clean the filters. Run the pre-
wash cycle.
Always wipe up spilled rinse agent immediately.
EN 21