Summary of Contents for Rockford Fosgate Power Series
Page 1
Installation & Systems Operation T152S Installation et fonctionnement T162S Instalación y funcionamiento T1682S Einbau und Betrieb Installazione e funzionamento Tweeter Power Series Component Systems...
NTRODUCTION Dear Customer, Congratulations on your purchase of the world's finest brand of car audio speakers. At Rockford Fosgate we are fanatics about musical reproduction at its best, and we are pleased you chose our product.Through years of engi- neering expertise, hand craftsmanship and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve.
Installation Section of this manual. Other information can be located by using the Table of Contents.We, at Rockford Fosgate, have worked very hard to make sure all the information in this manual is current. But, as we are constantly finding new ways to improve our product, this information is subject to change without notice.
Make sure there is a flat area large enough for the crossover to mount. 2. For best results, mount the crossover(s) next to the amplifier for a decorative finish to the installation and provide an easy upgrade (no new wires to run) for a bi-amp Rockford Fosgate system in the future.
Page 5
NSTALLATION WEETERS Use this section when installing Tweeters or Systems A solid front stage with a good image is one of the most difficult tasks to achieve in a vehicle. No car has the optimum listening environment.This makes proper sound staging very difficult to accomplish. Most speakers tend to be placed where they will fit easily, as opposed to where they can perform the best.The mounting location of your speakers will have a great effect on the sound quality of your stereo system.
NSTALLATION WEETERS Wiring Tweeter to Crossover Use illustrations for proper connection. Be sure to maintain speaker polarity Setting Crossover 0dB Tweeter Level matches the amplitude of the tweeter to the speaker -2dB/-4dB Tweeter Level reduces the amplitude of the tweeter -2dB or -4dB lower than the midrange. (ex.
NSTALLATION PEAKERS NOTE:When NOT bi-amping the crossover, connect to the MID inputs only.The jumpers must be in the "Normal" position. Connect from Source or Amplifier Use this section when installing Systems Cut the proper size hole for the speaker. NOTE: See Specifications for proper hole size. Place the mounting ring over the mounting hole and mark the location of the screw mounting holes.
ROUBLESHOOTING Symptom Diagnosis Remedy Check wiring, repair or replace. Wires not connected properly. No sound from speakers Check with working amplifier and re- Amplifier has no output. pair or replace as needed. Check wiring with a volt/ohm meter Speaker wires are shorted to each and repair or replace as needed other or to the chassis of vehicle.
Some states do not allow limitations on the length of an implied warranty, so this limitation may not apply. No person is authorized to assume for Rockford Fosgate any other liability in connection with the sale of the product. How to Obtain Service Contact the Authorized Rockford Fosgate Dealer you purchased this product from.