Table of Contents
Advertisement
Fan run-on time
Switching on
Touch the
symbol.
y
The fan runs at fan setting 1.
The remaining minutes of the run-on time are shown in
the display.
After approx. 10 minutes, the fan switches off
automatically.
You can use the rotary selector to adjust the run-
Note:
on time (
to
minutes).
‚
ŠŠ
Switching off
Touch the
symbol.
y
This immediately stops the fan run-on. The appliance
switches to the fan setting that was previously set.
Decorative LED lighting
The decorative LED lighting can be switched on and off
independently of the fan.
Touch the
symbol.
l
Setting the brightness
Press and hold the
symbol until the required
l
brightness is reached.
Setting the colour
Switch off the fan.
1.
Touch the
symbol.
l
2.
Use the control ring to select the colour you want.
3.
Colour temperature settings are available in the
Note:
Home Connect app provided the appliance has this
function.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
symbol.
B
Setting the brightness
Press and hold the
symbol until the required
B
brightness is reached.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols flash once the
appliance has been switched off:
E
Metal grease filter:
■
Activated charcoal filter:
■
Metal grease filter and activated charcoal filter:
■
and
F
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 13
The saturation displays can be reset while they are
flashing. To do this, touch the
Switching over the display for the air circulation
mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Touch and hold the
■
selector to change the display to 2. Take your finger
off the
symbol. This switches the electronic
:
controller over to air recirculation mode (filters that
cannot be regenerated).
Touch and hold the
■
selector to change the display to 3. Take your finger
off the
:
symbol. This switches the electronic
controller over to air recirculation mode (filters that
can be regenerated).
Repeatedly touching and holding the
■
changing the display to "1" switches the electronic
controller back to air extraction mode.
Audible signal
Switching on
Touch and hold the
#
time for approximately three seconds when the fan is
switched off. As confirmation, an audible signal sounds
and
is shown in the display.
‚
Switching off
Touch and hold the
#
time for approximately three seconds when the fan is
switched off. As confirmation,
Operating the appliance
F
or
symbol.
E
F
symbol. Use the rotary
:
:
symbol. Use the rotary
symbol and
:
and
symbols at the same
y
and
symbols at the same
y
is shown in the display.
‹
en
E
9
Advertisement
Table of Contents
