Operation - ACDelco ARI12105 Product Information Manual

INSTALLING OR REMOVING BATTERY PACK
TO REMOVE BATTERY PACK: Depress the battery pack release button (8) and pull
the battery pack (9) out of tool.
TO INSTALL BATTERY PACK: Push the battery pack (9) onto tool until it locks in
place.
INSTALLING BITS
Always follow the procedure below to install a driver bit:
1. Pull the guide sleeve (2) forward.
2. Insert the bit into the hexagonal hole.
3. By releasing the guide sleeve it will return to its original position.
REMOVING BITS
Always follow the procedure below to remove a driver bit:
1. Pull the guide sleeve (2) forward.
2. Take the bit out from the hexagonal hole.
3. By releasing the guide sleeve it will return to its original position.
CAUTION
NOTE
Always check the direction of the rotation before use.
1. After continuous use, allow the impact driver to sit idle for 15 minutes before
replacing the battery. The temperature of the motor, switch, etc., will rise if the
work is started again immediately after the battery has been changed, eventually
resulting in burned-out.
2. Place the point of the bolt in the socket. Keep the tool pointed straight at the bolt.
3. Apply forward pressure to the tool to prevent the socket from slipping off the bolt.
4. To start, turn impact wrench/driver on. Always check torque with a torque wrench.
The fastening torque can be affected by many factors including the following:
Voltage: Low voltage due to a nearly discharged battery will reduce the fastening
torque.
Socket Size: Failure to use the correct socket size will cause a reduction in fastening
torque.
Variable Speed Trigger Switch: Operating the tool at a reduced speed will reduce the
fastening torque.
1English1
ASSEMBLY
Always set switch (6) to off position when installing and
removing bit.

OPERATION

English -8