LG TH2112DSAL Owner's Manual page 84

Symptoms
Washing machine
will not operate
Washing machine
not filling
properly
Washing machine
will not drain
water
38
Reason
Control panel has powered
off due to inactivity.
Washing machine is
unplugged.
Water supply is turned off.
Controls are not set properly.
Door is open.
Circuit breaker/fuse is
tripped/blown.
Control needs to be reset.
START/PAUSE was not
pressed after a cycle was set.
Extremely low water
pressure.
Washing machine is too cold.
Washing machine is heating
the water or making steam.
Filter clogged.
Supply hoses may be kinked.
Insufficient water supply.
Hot and cold supply hoses
are reversed.
Kinked drain hose.
Drain located higher than 1.2
m above the floor.
Solution
• This is normal. Press the POWER button to turn
the washing machine on.
• Make sure cord is plugged securely into a
working outlet.
• Turn both hot and cold taps fully on.
• Make sure the cycle was set correctly, close the
door and press the START/PAUSE button.
• Close the door and make sure that nothing is
caught under the door preventing it from closing
completely.
• Check house circuit breakers/fuses. Replace
fuses or reset breaker. The washing machine
should be on a dedicated branch circuit. The
washing machine will resume the cycle where it
stopped once power is restored.
• Press the POWER button, then reselect
the desired cycle and press the START/PAUSE
button.
• Press the POWER button then reselect
the desired cycle and press the START/PAUSE
button. The washing machine will shut off if the
START/PAUSE button is not pressed within 60
minutes.
• Check another tap in the house to make sure
that household water pressure is adequate.
• If the washing machine has been exposed to
temperatures below freezing for an extended
period of time, allow it to warm up before
pressing the POWER button.
• The washing machine drum may stop operating
temporarily during certain cycles, while water is
safely heated to a set temperature.
• Make sure the inlet filters on the fill valves are
not clogged.
• Check that supply hoses are not kinked or
clogged.
• Make sure that both hot and cold water taps are
turned on all the way.
• Check supply hose connections.
• Ensure that the drain hose is not kinked.
• Make sure that the drain hose is no higher than
1.2 m above the bottom of the washing machine.
EN