Whirlpool WDT975SAHV User Instructions page 12

OPTION SELECTIONS
Runs dishwasher at a later time. Select a wash
cycle and options. Each time you press the Delay
keypad, it will display the next available delay time.
Press START/RESUME, then close the door firmly.
NOTES:
The dishwasher remembers the last delay you
■
selected. To reset the delay time to something
(varies by
other than what is displayed, continue to press
model)
the Delay keypad until the desired delay time
is reached.
Anytime the door is opened (such as, to add
■
a dish), the Start/Resume keypad must be
pressed again to resume delay countdown.
Raises main wash temperature to improve cleaning
for loads containing tough, baked-on food.
Dries dishes with heat. This option, with the use
of rinse aid, will provide better drying performance.
Plastic items are less likely to deform when loaded
in the top rack. Use Heat Dry for optimum dry
performance. Turn the Heat Dry option off for
air dry.
Extended Dry lengthens the time that Heat Dry
is active. This option with the use of rinse aid will
provide better drying performance.
Sanitizes dishes and glassware in accordance
with NSF International NSF/ANSI Standard 184
for Residential Dishwashers. Certified residential
dishwashers are not intended for licensed food
establishments. Only sanitizing cycles have been
designed to meet the requirements of the NSF/
ANSI 184 performance standard for soil removal
and for sanitization efficacy. There is no intention,
either directly or indirectly, that all cycles on a
(location of
NSF/ANSI 184 certified dishwasher meet the NSF/
"Sanitized"
ANSI 184 performance standard for soil removal
indicator varies
and for sanitization efficacy.
by model)
At end of the cycle, the "Sanitized" indicator will
glow. If your load did not properly sanitize, the
indicator will flash at the end of the cycle. This can
happen if the cycle is interrupted or if the water
does not reach the required temperature. The light
goes off when you open and close the door or
press CANCEL.
Avoids unintended use of dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Lock, press and hold CONTROL LOCK for 3 seconds. Control Lock light will stay on for a short time,
indicating that it is activated and all keypads are disabled. If you press any keypad while your dishwasher is locked,
light flashes 3 times. Dishwasher door can still be opened/closed while the controls are locked.
To turn off Lock, press and hold CONTROL LOCK for 3 seconds. Light turns off.
12
OPTIONS CAN BE WHAT IT DOES ADDED
SELECTED
WITH
Available with Delays start of
any cycle
a cycle up to
24 hours.
Sensor Raises the
Heavy main wash
Normal
temperature to
Soak & Clean
135°F (57°C).
Sensor
Uses heating
Heavy element to speed
Normal drying times.
Soak & Clean
Heat Dry option
defaults to on
when any cycle is
selected, except
for 1-Hour Wash.
Sensor
Raises the
Heavy main wash
Normal temperature to
135°F (57°C) and
the final rinse
temperature to
156°F (69°C).
ADDED
TIME TO WATER
CYCLE GALLONS
(LITERS)
NA NA
0:05 to 0:13 0 to 3.86
(0 to 14.6)
0:08 to 0:46 0
0:05 to 1:06 0 to 3.86
(0 to 14.6)