Tenda W322UA User Manual page 52

Wireless Network Adapter Users' Guide
wireless network adapter and re-switch to AP mode.
Q4: Client can not obtain IP when connected to soft AP of
the wireless network adapter.
A4: Manually set a IP address at the same net segment
as that of AP and the gateway at the IP address of AP. And
communication can be achieved.
Q5: Some function buttons on UI become grey and can
not be used.
A5: This is because you have switched to Zero config
mode, please right click the Tenda UI ON the right-down
corner of your desktop. Operations can be done after you
have switched to Tenda UI.
Q6: In Windows 2000 system, IP address can not be
obtained when it is switched to AP Mode.
A6: In Windows 2000 system, you have to manually
configure share and then switch to AP. And an IP address
of 192.168.0.1 will be obtained.
Eu Declaration or Declaration of Conformity
Hereby, SHENZHEN TENDA TECHNOLOGY CO.,LTD,
declares that this Wireless Broadband Router is in
compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
-48-