Table of Contents
Advertisement
Available languages
Available languages
Important safety information
For your safety, follow all safety information contained in these instructions prior to using
this product. Retain these instructions for future reference.
Intended use statement
The Cinemin™ multimedia pico projector is designed to operate using its battery and
power adapter and in a home environment.
•
10˚–27˚C (50˚–80˚F)
•
10–80% RH (without condensation)
•
0–1,829 m (0–6000') above sea level
The ambient operating environment should be free of airborne smoke, grease, oil and
other contaminants that can affect the operation or performance of the projector.
Use of this product in adverse conditions will void the product warranty.
Warnings and cautions
•
Do not modify this product in any way.
•
Do not attempt to service this projector.
•
Do not use the power adapter in a wet environment
•
Do not use with a damaged power supply. Replace damaged part prior to use.
•
Do not immerse the projector or battery in any liquid or allow either to get wet.
•
Use only power adapter and battery provided.
•
Do not disassemble, short or expose the battery to high temperature.
•
Do not overcharge or rapidly discharge the battery.
•
Do not dispose of the battery by incineration or fire.
•
Do not operate this projector in any environment above 100°F (38°C).
•
Do not expose the projector or battery to direct sunlight in a closed space such
as a vehicle.
•
Do not use this projector in a moving motor vehicle.
•
Do not stare directly into the LED light beam.
•
Position the charging cord and data cables so that they can not be tripped over.
•
Position the equipment near a power outlet when where it can be easily accessed
when plugged in.
•
Do not point the light directly or indirectly in eyes.
•
Do not use equipement if the lens is damaged.
14
Important battery information
•
Use only fresh batteries of the required size and recommended type.
•
Rechargeable batteries are only to be charged under adult supervision.
•
Respect the correct polarity, (+) and (-).
•
Do not throw batteries into the fire.
•
The supply terminals are not to be short-circuited.
•
Remove batteries if the product is not going to be used for some time.
•
The battery will only recharge when the battery temperature is below 40°C (104° F).
The equipment that you have purchased has required the
extraction and use of natural resources for its manufacturing.
It may contain substances that are hazardous to health and
the environment. In order to prevent the release of these
substances into the environment and to reduce the pressure on
natural resources, we encourage you to use appropriate return
systems. These systems will ensure that most of the materials
in your equipment are properly reused or recycled at the end
of its operational life. The crossed-bin symbol invites to use
these systems. For further information on collection, reuse and recycling
systems, please contact your regional waste management administration.
This symbol is only valid in the European Union. If you wish to discard this product,
please contact your local authorities or dealer and ask for the correct method of disposal.
Failure to follow the instructions contained wtihin this product
manual or in accordance with the intended use statement, will
void all warranties and limited remedies.
Compliancy
CE statement
Electromagnectic compatibility statement: Meets 2004/108/EC Directive
Low Voltage Directive: Meets 2006-95-EC Directive.
RoHS statement
This product meets RoHS certification for products meeting the RoHS directive.
European (EU) Restriction of Hazardous Substances (RoHS) Directive, 2002/95/EC,
* RoHS compliant means that the product or part does not contain any of the
substances in excess of the following maximum concentration values in any
homogeneous material, unless the substance is in an application that is exempt under
RoHS, as amended:(a) 0.1% (by weight) for lead, mercury, hexavalent chromium,
polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0.01% (by weight)
for cadmium. This information represents WowWee's knowledge and belief, which may
be based on information provided by third party suppliers.
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
For these purposes, the party responsible is:
WowWee USA Inc.
5963 La Place Court, Suite #207
Carlsbad, CA 92008, USA
NOTE
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try and correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
•
Consult the dealer or experienced radio/TV technician for help
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
*
Advertisement
Table of Contents
